No abstract

A mixed microbial population naturally presents in seawater was used as active anodic biofilm of two Microbial Fuel Cells (MFCs), employing either a 2D commercial carbon felt or 3D carbon-coated Berl saddles as anode electrodes, with the aim to compare their electrochemical behavior under continuous operation. After an initial increase of the maximum power density, the felt-based cell reduced its performance at 5 months (from 7 to 4 μW cm(-2)), while the saddle-based MFC exceeds 9 μW cm(-2) (after 2 months) and maintained such performance for all the tests. Electrochemical impedance spectroscopy was used to identify the MFCs controlling losses and indicates that the mass-transport limitations at the biofilm-electrolyte interface have the main contribution (>95%) to their internal resistance. The activation resistance was one order of magnitude lower with the Berl saddles than with carbon felt, suggesting an enhanced charge-transfer in the high surface-area 3D electrode, due to an increase in bacteria population growth.

The updated Bioeconomy Strategy document “A sustainable bioeconomy for Europe: strengthening the connection between economy, society and the environment”, which was issued by the European Commission in October 2018, encourages the exploitation of organic wastes according to a pyramidal hierarchy in which the extraction of valuable biomolecules, which will be used as they are or as precursors of high‐added‐value compounds, is a priority in biofuel production. This review considers a biorefinery platform in which food waste and sewage sludge are adopted to produce volatile fatty acids (VFAs) through a dark fermentation process. VFA fermentation is optimized by slightly acid pH (6–7), short hydraulic retention time (1–7 days) and high organic load rate (more than 10 gTS L−1 d−1). Attention has been focused on VFA exploitation for polyhydroxyalkanoate (PHA) production via a ‘feast and famine’ strategy performed in sequencing batch reactors. The obtained PHA yields are around 0.4–0.5 gPHA gCOD−1. Moreover, VFAs allow for the production of biofuels, such as hydrogen and methane, through single‐ or double‐staged anaerobic digestion. Innovative bioelectrochemical upgrade strategies for biogas helps producers to obtain biomethane for the automotive sector. Moreover, biogas has recently been tested for the production of polyhydroxybutyrate, a biodegradable and biocompatible thermoplastic made by microorganisms from C1 carbon sources (CO2 and CH4). Digestates from anaerobic bioreactors are still rich in nitrogen and phosphorus compounds. These latter compounds have been identified as critical raw materials due to their low availability in the European Union and to increasing demand from the growing global population. Thus, nutrient recovery from digestate allows users to close the loop of the ‘circular economy’ approach. © 2019 Society of Chemical Industry

The effect of anodic pH on Microbial fuel cells (MFCs) inoculated with marine consortia was investigated to characterize the microbial community adaptation to possible pH environmental changes and to define the pH extreme boundaries beyond which MFCs do not run properly. Tests were conducted in triplicate using different feeding pH values (pHfeed) ranging from 3 to 13. The MFCs inoculated with marine consortia had a strong self-regulation ability and actively counterbalanced small variations in pHfeed maintaining the pH inside the anodic chamber (pHanode) close to neutrality. As soon as the pHanode deviated from neutrality it affected MFCs' performances. Alkaline conditions with pHanode values between 8 and 10 corresponded to the formation of a denser biofilm together with the best performance in terms of maximum power density (Pmax). Conversely, when the pHanode reached values lower than 5.5 or higher than 10, a sharp drop in MFC performances, as well as a decrease of viable population, were observed. Interestingly, the system was able to survive these extreme conditions and restart working effectively when neutrality was reset. The obtained results underline the high adaptability and recovery ability of anodic marine consortia even in extreme conditions, suggesting the employment of this inoculum for MFC applications as biosensors for on-site seawater monitoring or as power supply units to be installed in remote area.