When channel state information is known at a transmitter in multiple-input multiple-output systems, the optimum capacity is given by eigenmode channel division with water-pouring power control. In this eigenbeam-space division multiplexing (E-SDM), bit assignments to substreams based on the capacity is not optimum due to the fact that the number of assigned bits is expressed by discrete quantity. In the paper, a method to assign both bit and transmit power to each substream based on the criterion minimizing total bit error rate (BER) is developed, and the BER performance is numerically analyzed in comparison to spatial division multiplexing (SDM). The simulation results assuming 5-transmit and 2-receive antennas show that the E-SDM provides about 10 dB gain compared to the conventional SDM at average BER of 10 −3 . 0-7803-7467-3/02/$17.00 ©2002 IEEE.

No abstract

No abstract

No abstract

Abstract-Multiple-input multiple-output (MIMO) spatial multiplexing that needs to separate and detect transmitted signal streams by using processing at the receiver end can increase the data rates of transmissions on independent and identically distributed (i.i.d.) channels. Such channels have been considered to exist in nonline-of-sight (NLOS) environments. However, actual communications may also be conducted in line-of-sight (LOS) environments. While an LOS component can increase the received power level, it may also cause correlated channels that make it difficult to detect the transmitted streams. In this paper, we describe the performance of 4 4 MIMO spatial multiplexing based on LOS and NLOS channel measurements in an indoor environment. For eight configurations of uniform linear arrays (four antenna spacings and two array orientations), we evaluated the cumulative distribution function (CDF) of the channel capacity and bit error rate performance versus transmit power, and we analyzed them in terms of antenna pattern, fading correlation, CDFs of MIMO channel elements, and CDFs of eigenvalues. Results show that, despite higher fading correlations and non i.i.d. channel characteristics, the performance of MIMO spatial multiplexing in the LOS environment is better than that in the NLOS one. However, the performance in the measured LOS environment largely depends on the MIMO configuration.Index Terms-Array element pattern, bit error rate (BER), channel capacity, channel element distribution, eigenvalue distribution, fading correlation, indoor channel measurement, multiple-input multiple-output (MIMO), mutual coupling, spatial multiplexing.