No abstract

No abstract

Strengthening existing reinforced concrete (RC) slabs using externally bonded materials is increasingly popular due to its adaptability and versatility. Nevertheless, ductility reduction of the rehabilitated flexural members with these materials can lead to brittle shear failure. Therefore, a new approach for strengthening is necessary. This paper presents a methodology to induce ductile failure of flexural strengthened one-way RC slabs. Ultimate failure loads can be considered to develop the proposed design methodology. Different failure modes corresponding to ultimate failure loads for RC slabs are addressed. Flexural and shear failure regions of RC slabs can be established by considering the failure modes. The end span of the concrete slab is shown for a case study, and numerical examples are solved to prove the essentiality of this methodology.

The hybrid retrofit system using FRP and concrete overlay applied on the top of slabs has proven effective in strengthening and overcoming logistical constraints, compared with conventional strengthening techniques using externally bonded composite materials to the underside of the slabs. Nevertheless, the performance of retrofitted slabs is governed by debonding failure due to the low bond strength between CFRP and concrete overlay. Thus, this study investigates the behavior of flexural strengthened slabs with FRP retrofit systems and the effect of bond–slip laws on debonding failure. Firstly, two full-scale RC slabs with and without a retrofit system were tested in a four-point bending setup as the control specimens. Then, the same retrofitted slab was simulated by utilizing the commercial program ABAQUS. A sensitivity analysis was conducted to consider the influence of bond–slip laws to predict the failure mechanism of the retrofitted slabs based on load–deflection relationships. The results showed that the strengthened slab enhanced the load-carrying capacity by 59%, stiffness by 111%, and toughness by 29%. The initial stiffness of 0.1K0 and maximum shear stress of 0.13τmax, compared with the corresponding values of Neubauer’s and Rostasy’s bond–slip law, can be used to simulate the global response of the retrofitted slab validated by experiment results.