After the accident at the Fukushima nuclear power plant, filtered containment venting systems (FCVSs) have garnered increasing attention as an effective facility for nuclear accident management. FCVSs with a wet-type scrubber, a droplet separator, and several other stages for fine aerosol filtration are typical used of many countries. Most of these FCVSs comprise a self-priming venturi scrubber nozzle for air injection. An optimized design of the VS (in terms of the throat length, throat size, nozzle diameter, etc.,) may significantly improve the filtration efficiency of the nozzle and wet-scrubber filter. Furthermore, adding a baffle plate on top of the VS also can improve the efficiency of the wet-scrubber filter. In this study, to understand the effects of the baffle plate on the efficiency of the wet-scrubber filter, two VS nozzle configurations were used. The difference between these two configurations is that one of them involved a baffle plate installed above the outlet. The decontamination factors of the wet scrubbers using these two nozzle configurations were measured and compared. The two-phase flow pattern in the pool was observed using a high-speed camera. It is discovered that the baffle plate contributed to increase the efficiency of the wet-pool scrubber. Moreover, the aerated surface exhibits better stabilization when the baffle plate is used.

No abstract

No abstract

No abstract

After completion of design calculation of the Dalat Nuclear Research Reactor (DNRR) for conversion from high-enriched uranium fuel (HEU) to low-enriched uranium (LEU) fuel, the commissioning programme for DNRR with entire core loaded with LEU fuel was successfully carried out from 24 November 2011 to 13 January 2012. The experimental results obtained during the implementation of commissioning programme showed a good agreement with design calculations and affirmed that the DNRR with LEU core have met all safety and exploiting requirements.