No abstract

A multicompositional particulate Li[Ni0.9Co0.05Mn0.05]O2 cathode in which Li[Ni0.94Co0.038Mn0.022]O2 at the particle center is encapsulated by a 1.5 µm thick concentration gradient (CG) shell with the outermost surface composition Li[Ni0.841Co0.077Mn0.082]O2 is synthesized using a differential coprecipitation process. The microscale compositional partitioning at the particle level combined with the radial texturing of the refined primary particles in the CG shell layer protracts the detrimental H2 → H3 phase transition, causing sharp changes in the unit cell dimensions. This protraction, confirmed by in situ X‐ray diffraction and transmission electron microscopy, allows effective dissipation of the internal strain generated upon the H2 → H3 phase transition, markedly improving cycling performance and thermochemical stability as compared to those of the conventional single‐composition Li[Ni0.9Co0.05Mn0.05]O2 cathodes. The compositionally partitioned cathode delivers a discharge capacity of 229 mAh g−1 and exhibits capacity retention of 88% after 1000 cycles in a pouch‐type full cell (compared to 68% for the conventional cathode). Thus, the proposed cathode material provides an opportunity for the rational design and development of a wide range of multifunctional cathodes, especially for Ni‐rich Li[NixCoyMn1‐x‐y]O2 cathodes, by compositionally partitioning the cathode particles and thus optimizing the microstructural response to the internal strain produced in the deeply charged state.

This Perspective discusses the prospective strategies for overcoming the stability and capacity trade-off associated with increased Ni content in layered Ni-rich Li­[Ni x Co y Mn z ]­O2 (NCM) and Li­[Ni x Co y Al z ]­O2 (NCA) cathodes. The Ni-rich NCM and NCA cathodes have largely replaced the LiCoO2 cathodes in commercial batteries because of their lower cost, higher energy density, good rate capability, and reliability that has been extensively field-tested. Nevertheless, they suffer from microcrack generation along grain boundaries and Ni3+/4+ reactivity that rapidly deteriorate electrochemical performance. Doping and coating have been efficient strategies in delaying the onset of the damage, but they fail to overcome the degradation. There are, however, alternative strategies that directly counter the inherent degradation through micro- and nanostructural modifications of the Ni-rich NCM and NCA cathodes.

The formation of metallic lithium microstructures in the form of dendrites or mosses at the surface of anode electrodes (e.g., lithium metal, graphite, and silicon) leads to rapid capacity fade and poses grave safety risks in rechargeable lithium batteries. We present here a direct, relative quantitative analysis of lithium deposition on graphite anodes in pouch cells under normal operating conditions, paired with a model cathode material, the layered nickel-rich oxide LiNiCoMnO, over the course of 3000 charge-discharge cycles. Secondary-ion mass spectrometry chemically dissects the solid-electrolyte interphase (SEI) on extensively cycled graphite with virtually atomic depth resolution and reveals substantial growth of Li-metal deposits. With the absence of apparent kinetic (e.g., fast charging) or stoichiometric restraints (e.g., overcharge) during cycling, we show lithium deposition on graphite is triggered by certain transition-metal ions (manganese in particular) dissolved from the cathode in a disrupted SEI. This insidious effect is found to initiate at a very early stage of cell operation (<200 cycles) and can be effectively inhibited by substituting a small amount of aluminum (∼1 mol %) in the cathode, resulting in much reduced transition-metal dissolution and drastically improved cyclability. Our results may also be applicable to studying the unstable electrodeposition of lithium on other substrates, including Li metal.

O 2 (NCM) cathodes have been the archetypes of current high-energy-density cathodes for Li-ion batteries. A