Lithium-sulphur batteries have generated tremendous research interest due to their high theoretical energy density and potential cost-effectiveness. The commercial realization of Li-S batteries is still hampered by reduced cycle life associated with the formation of electrolyte soluble higher-order polysulphide (Li2Sx, x = 4–8) intermediates, leading to capacity fading, self-discharge, and a multistep voltage profile. Herein, we have realized a practical approach towards a direct transformation of sulphur to Li2S2/Li2S in lithium-sulphur batteries by alteration of the reaction pathway. A coconut shell derived ultramicroporous carbon-sulphur composite cathode has been used as reaction directing template for the sulphur. The lithiation/delithiation and capacity fading mechanism of microporous carbon confined sulphur composite was revealed by analyzing the subsurface using X-ray photoelectron spectroscopy. No higher-order polysulphides were detected in the electrolyte, on the surface, and in the subsurface of the cathode composite. The altered reaction pathway is reflected by a single-step profile in the discharge/charge of a lithium-sulphur cell.

Abstract:We have developed ah ighly active nanostructured iridium catalyst for anodes of proton exchange membrane (PEM) electrolysis.C lusters of nanosized crystallites are obtained by reducing surfactant-stabilized IrCl 3 in water-free conditions.T he catalyst shows af ive-fold higher activity towards oxygen evolution reaction (OER) than commercial Ir-black. The improved kinetics of the catalyst are reflected in the high performance of the PEM electrolyzer (1 mg Ir cm À2 ), showing an unparalleled low overpotential and negligible degradation. Our results demonstrate that this enhancement cannot be only attributed to increased surface area, but rather to the ligand effect and low coordinate sites resulting in ahigh turnover frequency (TOF). The catalyst developed herein sets ab enchmark and as trategy for the development of ultra-low loading catalyst layers for PEM electrolysis.

The oxygen fugacity f(O2)of the Earth's mantle is one of the fundamental variables in mantle petrology. Through ferric-ferrous iron and carbon-hydrogen-oxygen equilibria, f(O2) influences the pressure-temperature positions of mantle solidi and compositions of small-degree mantle melts. Among other parameters, f(O2) affects the water storage capacity and rheology of the mantle. The uppermost mantle, as represented by samples and partial melts, is sufficiently oxidized to sustain volatiles, such as H2O and CO2, as well as carbonatitic melts, but it is not known whether the shallow mantle is representative of the entire upper mantle. Using high-pressure experiments, we show here that large parts of the asthenosphere are likely to be metal-saturated. We found that pyroxene and garnet synthesized at >7 GPa in equilibrium with metallic Fe can incorporate sufficient ferric iron that the mantle at >250 km depth is so reduced that an (Fe,Ni)-metal phase may be stable. Our results indicate that the oxidized nature of the upper mantle can no longer be regarded as being representative for the Earth's upper mantle as a whole and instead that oxidation is a shallow phenomenon restricted to an upper veneer only about 250 km in thickness.

Oligoclase and labradorite crystals have been experimentally replaced by albite in an aqueous sodium silicate solution at 600°C and 2 kbars. The replacement is pseudomorphic and is characterised by a sharp chemical interface which progresses through the feldspar while preserving the crystallographic orientation. Reaction rims of albite, up to 50 lm thick, can be readily achieved within 14 days. Re-equilibration of plagioclase in an 18 O-enriched sodium-and silica-bearing solution results in oxygen isotope redistribution within the feldspar framework structure. The observed characteristics of the reaction products are similar to naturally albitised plagioclase and are indicative of an interface-coupled dissolution-reprecipitation mechanism. Chemical analyses demonstrate that the albitisation is accompanied by the mobilisation of major, minor and trace elements also including elements such as Al and Ti which are commonly regarded as immobile during hydrothermal alteration. The results contribute to developing our understanding of the close association between large-scale albitisation and secondary ore mineralisation which is common in nature.

BackgroundCobalt-ferrite nanoparticles (Co-Fe NPs) are attractive for nanotechnology-based therapies. Thus, exploring their effect on viability of seven different cell lines representing different organs of the human body is highly important.MethodsThe toxicological effects of Co-Fe NPs were studied by in-vitro exposure of A549 and NCIH441 cell-lines (lung), precision-cut lung slices from rat, HepG2 cell-line (liver), MDCK cell-line (kidney), Caco-2 TC7 cell-line (intestine), TK6 (lymphoblasts) and primary mouse dendritic-cells. Toxicity was examined following exposure to Co-Fe NPs in the concentration range of 0.05 -1.2 mM for 24 and 72 h, using Alamar blue, MTT and neutral red assays. Changes in oxidative stress were determined by a dichlorodihydrofluorescein diacetate based assay. Data analysis and predictive modeling of the obtained data sets were executed by employing methods of Knowledge Discovery from Data with emphasis on a decision tree model (J48).ResultsDifferent dose–response curves of cell viability were obtained for each of the seven cell lines upon exposure to Co-Fe NPs. Increase of oxidative stress was induced by Co-Fe NPs and found to be dependent on the cell type. A high linear correlation (R2=0.97) was found between the toxicity of Co-Fe NPs and the extent of ROS generation following their exposure to Co-Fe NPs. The algorithm we applied to model the observed toxicity belongs to a type of supervised classifier. The decision tree model yielded the following order with decrease of the ranking parameter: NP concentrations (as the most influencing parameter), cell type (possessing the following hierarchy of cell sensitivity towards viability decrease: TK6 > Lung slices > NCIH441 > Caco-2 = MDCK > A549 > HepG2 = Dendritic) and time of exposure, where the highest-ranking parameter (NP concentration) provides the highest information gain with respect to toxicity. The validity of the chosen decision tree model J48 was established by yielding a higher accuracy than that of the well-known “naive bayes” classifier.ConclusionsThe observed correlation between the oxidative stress, caused by the presence of the Co-Fe NPs, with the hierarchy of sensitivity of the different cell types towards toxicity, suggests that oxidative stress is one possible mechanism for the toxicity of Co-Fe NPs.