Abstract-The thermal neutron SEU cross-section of the Toshiba SRAM memory used in the LHC RadMon system was measured at different voltages. A method using the difference in its response compared to mixed particle energy field is proposed to be used as a discriminator between thermal neutron and high-energy hadron fluences. For test purposes, the proposed method was used at the CNGS and CERF facilities to estimate the field composition by counting SEUs at two different voltages and the results were compared to simulations.

Abstract. This paper presents the results of a round robin exercise carried out to compare specific activity measurements performed by eight European organisations on a set of ten neutron activation detectors containing the radio-nuclides 110m Ag, 60 Co, 54 Mn, 46 Sc and 94 Nb. The purpose of the exercise was to demonstrate the level of consistency between the participating organisations in blind tests of measurements relevant to reactor metrology. The samples used were selected from a stock of pre-existing irradiated material held at SCK•CEN. Taking turns over a period of approximately 9 months, the participating organisations received the samples, measured them and provided their results to an independent referee who collated and compared the data. The inter-comparison has demonstrated good agreement between the participants with standard deviations for each dosimeter varying between 1.6% and 3.1%. The paper provides results of the EWGRD Round Robin in an anonymised form together with discussion and conclusions which may be drawn from the exercise.

Gamma dose and thermal neutron fluence in a phantom exposed to an epithermal neutron beam for boron neutron capture therapy (BNCT) can be measured by means of a single thermoluminescence dosemeter (TLD-700). The method exploits the shape of the glow curve (GC) and requires the gamma-calibration GC (to obtain gamma dose) and the thermal-neutron-calibration GC (to obtain neutron fluence). The method is applicable for BNCT dosimetry in case of epithermal neutron beams from a reactor because, in most irradiation configurations, thermal neutrons give a not negligible contribution to the TLD-700 GC. The thermal neutron calibration is not simple, because of the impossibility of having thermal neutron fields without gamma contamination, but a calibration method is here proposed, strictly bound to the method itself of dose separation.

The reliability of Fricke gel dosimeters in form of layers for measurements aimed at the characterization of epithermal neutron beams has been studied. By means of dosimeters of different isotopic composition (standard, containing (10)B or prepared with heavy water) placed against the collimator exit, the spatial distribution of gamma and fast neutron doses and of thermal neutron fluence are attained. In order to investigate the accuracy of the results obtained with in-air measurements, suitable MC simulations have been developed and experimental measurements have been performed utilizing Fricke gel dosimeters, thermoluminescence detectors and activation foils. The studies were related to the epithermal beam designed for BNCT irradiations at the research reactor LVR-15 (Řež). The results of calculation and measurements have revealed good consistency of gamma dose and fast neutron 2D distributions obtained with gel dosimeters in form of layers. In contrast, noticeable modification of thermal neutron fluence is caused by the neutron moderation produced by the dosimeter material. Fricke gel dosimeters in thin cylinders, with diameter not greater than 3mm, have proved to give good results for thermal neutron profiling. For greater accuracy of all results, a better knowledge of the dependence of gel dosimeter sensitivity on radiation LET is needed.

Hall sensors offer an attractive true non-inductive method of magnetic field measurements for fusion reactors. Their use for steady state magnetic diagnostics of ITER is presently limited by their questionable radiation and thermal stability. Issues of stable and reliable operation in ITER like radiation and thermal environment are addressed by the contribution. Recently, novel Hall sensors, compatible with temperatures up to 200 • C, were developed and their radiation stability was tested at LVR-15 experimental fission reactor. Overview of the experimental set-up on LVR-15 reactor is given. Degradation of the sensor's sensitivity by several tens of percents was observed after neutron irradiation by the total neutron fluence of 2 × 10 17 n/cm 2 in LVR-15. This level of neutron fluence is comparable to that expected to occur over the whole ITER life time for a sensor location just outside the ITER vessel. The in-situ recalibration techniques are expected to handle the observed degree of Hall sensors performance degradation in ITER environment.PACS : 52.55.Fa