No abstract

No abstract

The results of a study on the energy and noise characteristics of a DC/DC converter for batterypowered devices that maintains a stabilized output voltage at an input voltage lower than, higher than, or equal to the output voltage and maximizes battery use with the minimum size of external components are presented. The features of switching processes in transient modes of operation are considered. Circuit modeling makes it possible to clarify the characteristics of the processes, minimize conversion losses, and formulate recommendations for the choice of parameters of the transducer elements and the formation of control signals.

Non-inductive (throttle-free) DC/DC converters are used in low-power and highly integrated electronic systems. A circuit analysis of the basic topologies of non-inductive DC/DC charge-pumped converters which perform typical DC-voltage conversions, i.e., lowering, raising and inverting, was carried out. The galvanic isolation between the input and output circuits of the converter was achieved even in the integrated version due to forming a time delay of the switches (Dead Time, DT), commuting a “flying” capacitor, which is transferring the charge to the storage capacitor and the load. A circuit of the DT driver was developed and its parameters, at which the through-current flow in the switch is prevented and the conditions of galvanic isolation of the input and output circuits are satisfied, were studied. The simulation was built with a popular Electronics Workbench software, widely used in training of specialists in radio electronics at higher educational institutions. The results of the study of the basic power characteristics of DC/DC conversion, such as output current and voltage, voltage transfer coefficient, efficiency, output equivalent resistance, were presented. The efficiency of conversion was estimated by varying the capacities of the “flying” and storage capacitors, the resistance of the switches in the closed state, and the frequency of switching. It is proved that the charge pumping method is simple and effective at low load currents (mA units), when both the voltage transfer coefficient from input to output and efficiency are high, and are approaching to “one”. However, with the increase of the load current, the voltage transfer coefficient and efficiency decrease, the output voltage ripples increase.

No abstract