No abstract

No abstract

In this paper, the study of the influence of nano-silica (nano-SiO2) on the properties of the interface between CSH gel and cement particles and its effect on nano-mechanical properties of the products at the interface zone was examined. In this paper M50 grade SCC mixes were developed using 5% micro-silica and various percentages of 0.5%, 1.0% and 1.5% nano-SiO2. For 1.0% nano-SiO2 addition to M50 grade SCC mix, the compressive strength is maximum. Similarly concrete quality using non-destructive techniques, water absorbtion capacity and porosity are also assessed.

Very limited guidelines are available on the use of corrosion resistant inhibitors as a constituent material in concrete due to availability of statistics on its corrosion inhibiting efficiency. So the study is conducted on the M25 grade concrete mixed with few selected corrosion inhibitors of organic and non-organic nature to comprehend the impact of these corrosion inhibitors on the conductivity of electricity in these concretes. Based on the other researchers’ work, four well know corrosion inhibitors such as Calcium nitrate, Di-ethanolamine, Sodium nitrite and Hexamine and are chosen for study. Dosages of 1%, 2%, 3%, 4% and 5% the weight of cement are chosen. Measured electrical resistivity and half-cell potential values of all corrosion inhibitors admixed M25 grade concrete mixes indicates the superior corrosion inhibition ability of calcium nitrate and Di-ethanolamine’s with shows high electrical resistance.

Lately, development of concrete using industrial byproducts has garnered major significance in the construction industry in order to overcome problems associated with depleted natural resources. As, river sand is costly and also large scale exhaustion of these sources generates environmental harms, a substitute or replacement product for concrete industry is very indispensable. In such a situation, the copper slag can be proposed as an alternative to the river sand, which is an industrial by-product obtained from the manufacturing of copper. The present investigation assesses the incorporation of copper slag in concrete (CSC). In this paper, experimental investigations are carried to understand the flexural characteristics such as such as first crack, ultimate load carrying capacity, maximum crack width and deflection at service load and at centre of steel fibred copper slag mixed under-reinforced concrete beams. Results showed that the compressive strength of concrete decreases as copper slag content increases beyond 40%. The reduction in compressive strength beyond 40% replacement of river sand due to the increase in free water content in concrete mixes due to the low absorption properties of copper slag which can cause excessive bleeding at higher copper slag content. The load-deflection behaviour of under-reinforced, normal and copper slag concrete beams is witnessed to be alike apart from the increased values of ultimate failure loads and ultimate deflections at failure in steel fibred copper slag concrete beams.