This work aims to develop a multi-component evaporation model for droplets of urea-watersolution (UWS) and a thermal decomposition model of urea for automotive exhausts using the Selective Catalytic Reduction (SCR) systems. In the multi-component evaporation model, the influence of urea on the UWS evaporation is taken into account using a NRTL activity model. The thermal decomposition model is based on a semi-detailed kinetic scheme accounting not only for the production of ammonia (NH 3 ) and isocyanic acid (HNCO), but also for the formation of heavier solid by-products (biuret, cyanuric acid and ammelide). This kinetics model has been validated against gaseous data as well as solid-phase concentration profiles obtained by Lundstroem et al. (2009) andSchaber et al. (2004). Both models have been implemented in IFP-C3D industrial software in order to simulate UWS droplet evaporation and decomposition as well as the formation of solid by-products. It has been shown that the presence of the urea solute has a small influence on the water evaporation rate, but its effect on the UWS temperature is significant. In addition, the contributions of hydrolysis and thermolysis to urea decomposition have been assessed. Finally, the impacts of the heating rate as well as gas-phase chemistry on urea decomposition pathways have been studied in detail. It has been shown that reducing the heating rate of the UWS causes the extent of the polymerization to decrease because of the higher activation energy.
Spray cooling of the superheated steam occurs with the interaction of many complex physical processes, such as initial droplet formation, collision, coalescence, secondary break up, evaporation, turbulence generation, and modulation, as well as turbulent mixing, heat, mass and momentum transfer in a highly non-uniform two-phase environment. While it is extremely difficult to systematically study particular effects in this complex interaction in a well defined physical experiment, the interaction is well suited for numerical studies based on advanced detailed models of all the processes involved. This paper presents results of such a numerical experiment. Cooling of the superheated steam can be applied in order to decrease the temperature of superheated steam in power plants. By spraying the cooling water into the superheated steam, the temperature of the superheated steam can be controlled. In this work, water spray cooling was modeled to investigate the influences of the droplet size, injected velocity, the pressure and velocity of the superheated steam on the evaporation of the cooling water. The results show that by increasing the diameter of the droplets, the pressure and velocity of the superheated steam, the amount of evaporation of cooling water increases. .
Urinary tract infection (UTI) is one of the diseases that despite multiple treatment andmany antibiotics used for it, still has many mortality and Morbidity 1 .Urinary tract is normally sterile and urinary tract infection occurs when the bacteria, viruses, fungi and parasites come to this system. Its
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.