No abstract

Quasi static time-series simulations (QSTS) of distribution feeders are a critical element of distributed solar PV integration studies. QSTS are typically carried out through computer simulation tools such as OpenDSS. Since a typical feeder contains thousands of buses, for long investigation periods or at fine time scales such simulations are computationally costly. Simulation times are reduced in this paper through a reduction of the number of buses in the model. The feeder reduction algorithm considers p-phase distribution feeders with unbalanced loads and generation, unbalanced wire impedance, and mutual coupling, while preserving the spatial variation of load and generation. An extensive Monte Carlo sensitivity analysis was performed on a real feeder from a California utility. All bus voltage differences are found to be less than 1.13% with a root mean square error of 0.21%. Simulation time savings were up to 96% when only one bus is selected to remain in the model. Example applications of the proposed algorithm are interconnection studies of utility-scale photo-voltaic system to the distribution grid, siting analyses of other distributed energy resources (DERs), and dynamic behavior of devices in large systems such as smart inverters on distribution grids.

High solar Photovoltaic (PV) penetration on distribution systems can cause over-voltage problems. To this end, an Optimal Tap Control (OTC) method is proposed to regulate On-Load Tap Changers (OLTCs) by minimizing the maximum deviation of the voltage profile from 1 p.u. on the entire feeder. A secondary objective is to reduce the number of tap operations (TOs), which is implemented for the optimization horizon based on voltage forecasts derived from high resolution PV generation forecasts. A linearization technique is applied to make the optimization problem convex and able to be solved at operational timescales. Simulations on a PC show the solution time for one time step is only 1.1 s for a large feeder with 4 OLTCs and 1623 buses. OTC results are compared against existing methods through simulations on two feeders in the Californian network. OTC is firstly compared against an advanced rule-based Voltage Level Control (VLC) method. OTC and VLC achieve the same reduction of voltage violations, but unlike VLC, OTC is capable of coordinating multiple OLTCs. Scalability to multiple OLTCs is therefore demonstrated against a basic conventional rulebased control method called Autonomous Tap Control (ATC). Comparing to ATC, the test feeder under control of OTC can accommodate around 67% more PV without over-voltage issues. Though a side effect of OTC is an increase in tap operations, the secondary objective functionally balances operations between all OLTCs such that impacts on their lifetime and maintenance are minimized.

No abstract