Objective The aim of the study is to evaluate the effect of extrinsic pigmentation on the dimensional stability, hardness, detail reproduction, and color of a silicone after thermocycling.
Materials and Methods Sixty samples of MDX4–4210 silicone (Dow Corning Corporation Medical Products) with intrinsic pink pigment (H-109-P, Factor II) and intrinsic opacifier (TiO) were fabricated. Two groups were created: Group 1—only intrinsic pigmentation (H-109P, Factor II + TiO) (Control); and Group 2—intrinsic (H-109P, Factor II + TiO) and extrinsic (Tan FE - 215, Factor II) pigmentation. The following tests were performed for each group: dimensional stability, Shore A hardness, detail reproduction, and color. Readings for the tests were taken before and after thermocycling (2,000 cycles). For dimensional stability and hardness, two-way analysis of variance (ANOVA) was used. One-way ANOVA was used for the color test. In case of significant statistical difference, the Tukey test was applied (p <0.05). All samples achieved the same detail reproduction score, therefore, no statistical evaluation was performed.
Results For the dimensional stability test, comparing the initial time with the final time, there was a significant contraction in both groups after thermocycling. For the hardness test, comparing the time points, only group 1 showed a significant reduction in hardness after thermocycling. Groups 1 and 2 scored 2 for the detail reproduction test, before and after thermocycling. Comparing group 1 with group 2, there was no significant difference for color change.
Conclusion Based on the tests performed, extrinsic pigmentation did not show a negative effect on silicone, and therefore it can be indicated. The results of the dimensional, hardness, detail reproduction and color evaluations of the MDX4–4210 silicone were clinically acceptable in all cases in the groups with and without extrinsic pigmentation.
