Carrier dynamics and photoconductivity in epitaxial-grown low-temperature GaAs on nominal and vicinal Si(1 0 0) substrates (‘LT-GaAs/Si’) were studied to predict their actual performance as THz photoconductive antenna (PCA) detectors. An optical-pump terahertz-probe technique was used to obtain the transmittance, carrier lifetime and photoconductivity of two LT-GaAs/Si samples, grown using different substrates and different growth protocols. The LT-GaAs grown on Si(1 0 0) substrate with a 4° tilt to 〈1 1 0〉 has better crystallinity, in agreement with other reports; while the LT-GaAs layer grown on nominal Si(1 0 0) substrate, though more structurally defective, has a much faster electron trapping time. Fabricated test PCAs with either dipole or bowtie geometries confirm the characterization results. The photoconductivity and carrier lifetime results manifest in the PCA performance, in responsivity, and in detection bandwidth. The prototypes’ sensitivities, bandwidths and dynamic ranges show that with some growth optimization, LT-GaAs/Si can be tailored to create economical, broadband THz detectors.

A low-temperature-grown GaAs (LTG-GaAs) terahertz (THz) photoconductive antenna device with layer structure consisting of doped buffer demonstrated enhanced emission intensity and detection sensitivity. As THz emitter, a 116% increase is exhibited by the LTG-GaAs with doped buffer relative to its undoped counterpart at 9 V bias and 0.8 mW pump power with spectral distribution extending to ∼3 THz. As a THz detector, a dynamic range of 55 dB is obtained at 0.5 THz, which is 5 dB higher than its undoped counterpart. The device proved effective as a THz emitter at low operating bias and pump power while its detection characteristics are acceptable even at low incident THz powers.

No abstract

No abstract

We present the implementation of an efficient terahertz (THz) photoconductive antenna (PCA) emitter design that utilizes high mobility carriers in the two-dimensional electron gas (2DEG) of a modulation-doped heterostructure (MDH). The PCA design is fabricated with recessed metal electrodes in direct contact with the 2DEG region of the MDH. We compare the performance of the MDH PCA having recessed contacts with a PCA fabricated on bulk semi-insulating GaAs, on low temperature-grown GaAs, and a MDH PCA with the contacts fabricated on the surface. By recessing the contacts, the applied bias can effectively accelerate the high-mobility carriers within the 2DEG, which increases the THz power emission by at least an order of magnitude compared to those with conventional structures. The dynamic range (62 dB) and bandwidth characteristics (3.2 THz) in the power spectrum are shown to be comparable with the reference samples. Drude-Lorentz simulations corroborate the results that the higher-mobility carriers in the MDH, increase the THz emission. The saturation characteristics were also measured via optical fluence dependence, revealing a lower saturation value compared to the reference samples. The high THz conversion efficiency of the MDH-PCA with recessed contacts at low optical power makes it an attractive candidate for THz-time domain spectroscopy systems powered by low power fiber lasers.