Purpose of the work is improved approaches to ensure the required quality parameters of voltage in the traction network based on modern technologies and equipment in the application of power distribution system. Actuality. The introduction of high-speed traffic, increase weight standards Train necessitates increasing the carrying capacity of railways. Often the carrying capacity of existing sections electrified at 3.0 kV DC power supply unit limits. Such limitations include voltage decrease on the electric current collector below the allowable value for the normal operation of 2700 (2900 for high-speed V) and heating the contact wires, thereby losing their mechanical strength. Existing power supply system of RS, which have considerable installed traction substations, can not provide the required level of power density traction network for high-speed movement within 1.5 - 2 MW / km and, respectively, the required voltage quality. At the same time, the daily loading of a powerful traction substations in providing intensive schedule of trains does not exceed 20-25%, while the energy loss in traction network peak load increases and reaches 10-15% of the energy consumed. Thus, the existing system of power traction networks is not sufficiently effective and economical, even with the application of existing methods to strengthen them. In our view, the main limiting factor for a given quality of voltage in the traction network is the use of centralized power. From this, the development of measures to improve the quality of voltage in the traction network in the implementation of high-speed traffic in a growing scarcity of energy resources is an urgent task. Scientific novelty. Using distributed power supply system with adjustable supply points combined into intelligent power supply, which enables adaptive change the characteristics of the transfer, conversion and consumption and optimize the mode of functioning of the traction power supply is suggested for improving the quality of voltage in the traction network in the implementation of high-speed and heavy traffic. Practical significance. Improving the quality of voltage in the traction network by using the proposed circuit design traction power supply will ensure the desired mode voltage and power characteristics of the traction network in the implementation of high-speed and heavy traffic while reducing electricity losses by 20-30%.

No abstract

A new autonomous 4D nonlinear model with two nonlinearities describing the dynamics of change of voltage and current in the contact railway electric network is offered. This model is a connection of two 2D oscillatory circuits for current and voltage in the contact electric network. In the found system for the defined values of parameters an existence of limit cycles is proved. By introduction of new variables this system can be reduced to 5D system only with one quadratic nonlinearity. The constructed model may be used for the control by voltage stability in a direct current power supply system.

Purpose. Investigate the impact of current collection system parameters and external factors on the resource of friction pair “contact wire – contact strip”. Relevance. The level of electrified railways reliability depends on the reliability and durability of the individual objects of power supply system and the locomotive facilities, in turn, the current collection quality depends on design of contact network and pantographs, contact wires materials, contact strips and external influencing factors. The resource system “contact wire – contact strip” is an important technical and economic characteristics, and its average actual resource is much less established. It means that the actual resource does not reach the optimum value from an economic point. Increasing velocity of the electric rolling stock exacerbates the problem of improving the current collection quality, becomes an actual task of increasing the resource friction pair “ contact wire – contact strip” for mainline railways. Scientific novelty. This work determined the influence structural parameters of the friction pair, the current collection system parameters and external factors on the wear rate of the friction pair “contact wire – contact strip”. Proposed to create a predictive mathematical model that uses the dependence of the influencing parameters obtained in this work to assess the wear and resource of contact wire and contact strips. Practical importance. Developed the device for wear researching of friction pairs in laboratory conditions allows assessing the wear rate of the system “contact wire – contact strip” and their residual resource at different combinations of the friction pair and external factors. The obtained results allow us to construct a predictive mathematical model to evaluate wear rate of the elements of the friction pair “contact wire – contact strip” and identify their residual resource.

No abstract