The automobile industry is presently focusing on processing of advanced steels with superior strength-ductility combination and lesser weight as compared to conventional high-strength steels. Advanced high-strength steels are a new class of materials to meet the need of high specific strength while maintaining the high formability required for processing, and that too at reasonably low cost. First and second generation of advanced high-strength steels suffered from some limitations. First generation had high strength but low formability while second generation possessed both strength and ductility but was not cost effective. Amongst the different types of advanced high-strength steels grades, dual-phase steels, transformation-induced plasticity steels, and complex phase steels are considered as very good options for being extended into third generation advanced high-strength steels. The present review presents the various processing routes for these grades developed and discussed by different authors. A novel processing route known as quenching and partitioning route is also discussed. The review also discusses the resulting microstructures and mechanical properties achieved under various processing conditions. Finally, the key findings with regards to further research required for the processing of advanced high-strength steels of third generation have been discussed.

No abstract

<p>The present work significantly improved the mechanical strength of AISI 316L stainless steel by producing nano-sized grains. Steel was subjected to cold rolling followed by repetitive thermal cycling to produce ultra-fine/ nano-sized grains. The optimum processing parameters including extent of cold deformation, annealing temperature for thermal cycling, soaking period during each thermal cycle, and number of thermal cycles were determined through a systematic step-by-step procedure. After conducting thermal cycling under optimum conditions, a significant amount of grain size reduction was achieved. The effect of nano-sized grains on tensile deformation behavior was analysed. High cold deformation resulted in increased amount of stored strain energy. The stored strain energy accelerated the re-crystallisation kinetics during the thermal cycling process. Every thermal cycle resulted in irregular dispersal of stored energy. This irregular dispersal of stored energy favoured recrystallisation rather than grain growth and led to refinement of grains, in the absence of strain induced martensite. Repetitive thermal cycling promoted grain refinement and resulted in very significant grain size reduction with resultant grain size in the range of 800–1200 nm as compared to initial size of 90–120 μm. The resultant microstructure improved tensile strength by<br />106.8 per cent, from 590 MPa to 1220 MPa.</p>

No abstract

No abstract