In flotation, the size of mineral particles is one of the most important parameters: when the size becomes fine, collision efficiency of the particles and air bubbles becomes low, causing low flotation recovery. To improve the collision efficiency and flotation kinetics, agglomeration using the emulsified oil of finely ground chalcopyrite (D50 = 3.5 μm) was carried out before flotation. In this study, the effects of agitation strength during agglomeration, kerosene dosage and potassium amyl xanthate (KAX) dosage on the flotation were investigated. Agglomeration using emulsified oil improved Cu recovery because the median diameter of agglomerate increased. With increasing agitation strength, KAX and kerosene dosages, Cu recovery was further increased. Agglomeration-flotation of a mixture containing chalcopyrite and quartz with 1:1 ratio (w/w, weight by weight) showed that Si recovery in froth was low and did not change with varying conditions (agitation strength, KAX and kerosene dosages); however, Cu recovery was significantly improved with increasing agitation strength, KAX and kerosene dosages, and thus the separation efficiency was improved.

No abstract

No abstract

Flotation is a common mineral processing method used to upgrade copper sulfide ores; in this method, copper sulfide mineral particles are concentrated in froth, and associated gangue minerals are separated as tailings. However, a significant amount of copper is lost into tailings during the processing; therefore, tailings can be considered secondary resources or future deposits of copper. Particle–bubble collision efficiency and particle–bubble aggregate stability determines the recovery of target particles; this attachment efficiency plays a vital role in the selectivity process. The presence of fine particles in the flotation circuit is because of excessive grinding, which is to achieve a higher degree of liberation. Complex sulfide ores of markedly low grade further necessitate excessive grinding to achieve the maximum degree of liberation. In the flotation process, fine particles due to their small mass and momentum are unable to collide with rising bubbles, and their rate of flotation is very slow, further lowering the recovery of target minerals. This collision efficiency mainly depends on the particle–bubble size ratio and the concentration of particles present in the pulp. To overcome this problem and to maintain a favorable particle–bubble size ratio, different techniques have been employed by researchers to enhance particle–bubble collision efficiency either by increasing particle size or by decreasing bubble size. In this article, the mechanism of tailing loss is discussed in detail. In addition, flotation methods for fine particles recovery such as microbubble flotation, column flotation, nanobubble flotation, polymer flocculation, shear flocculation, oil agglomeration, and carrier flotation are reviewed, and their applications and limitations are discussed in detail.

Flotation is the conventional method for processing porphyry copper deposits, one of the most economically important sources of copper (Cu) worldwide. The rapidly decreasing grade of this type of Cu ore in recent years, however, presents serious problems with fine particle recovery using conventional flotation circuits. This low recovery could be attributed to the low collision efficiency of fine particles and air bubbles during flotation. To improve collision efficiency and flotation recovery, agglomeration of finely ground chalcopyrite (CuFeS2) (D50 = 3.5 μm) using emulsified oil stabilized by emulsifiers was elucidated in this study. Specifically, the effects of various types of anionic (sodium dodecyl sulfate (SDS), potassium amyl xanthate (KAX)), cationic (dodecyl amine acetate (DAA)), and non-ionic (polysorbate 20 (Tween 20)) emulsifiers on emulsified oil stability and agglomeration–flotation efficiency were investigated. When emulsifiers were added, the average size of agglomerates increased, resulting in higher Cu recovery during flotation. This dramatic improvement in flotation efficiency could be attributed to the smaller oil droplet size in emulsified oil and their higher stability in the presence of emulsifiers. The utilization of emulsifiers during agglomeration–flotation not only lowered the required agitation strength for agglomeration but also shortened the agglomeration time, both of which made the process easier to incorporate in existing flotation circuits.