Reliability of scoring dental arch relationships using intraoral 3D scans was superior to indirect digital and to plaster models; Subjects with UCLP preferred intra-oral 3D scanning to dental impressions, mirrored by parents/carers; This study supports the replacement of conventional impressions with intra-oral 3D scans in longitudinal evaluations of the outcomes of cleft care.

Introduction This study is aimed to compare kinematic gait data of patients who have undergone total and unicondylar knee replacement. Materials and methods This single-surgeon retrospective cohort study evaluated 13 patients with unilateral total knee arthroplasty (TKA) and 14 unicondylar knee arthroplasty (UKA). Gait analysis was carried out using a Vicon motion analysis system. The limits of knee flexion during stance phase, at heel strike and at loading response were measured. Results The total range of motion of the UKA knees was significantly greater than the TKA knees. UKA knees exhibited significantly greater knee extension during the stance phase than the TKA knees. Unlike TKA, UKA knees demonstrated improved knee flexion during the gait cycle when compared to the contralateral non-operated knee. The hips also demonstrated near normal hip flexion in UKA patients. Predictably, UKA knees had significantly greater varus compared with TKA in the coronal plane. Spatiotemporal variables demonstrated similar walking speed and step length to aid a fair comparison between knee replacement groups. Conclusions The UKA knees moved more physiologically in the sagittal plane with a greater range of motion during gait. Despite having a stiff gait pattern, the patients undergoing TKA demonstrated a more neutral alignment in the coronal plane. Neither type of knee arthroplasty restored knee kinematics to those of the non-operated side.

Introduction The aim of this study was to compare kinetical data from gait analysis of patients who have undergone total and uni-condylar knee replacement. Materials and methods Thirteen patients with unilateral total knee arthroplasty (TKA) and 13 unicondylar knee arthroplasty (UKA), were included, all performed by the same surgeon more than one year prior. The Vicon gait analysis system was used. Statistical power was calculated using SPSS. Results No significant difference was found in the spatiotemporal parameters of gait and survival years of the knee prosthesis between the two groups. The UKA group was found to have significantly larger moments than the TKA group in knee adduction on the operated side and knee flexion moment on the unoperated side during the loading phase. The maximum and minimum sagittal plane moments of the operated sides in the TKA group were significantly lower than the unoperated side. The difference was most significant at pre-swing. The maximum and minimum moments on the operated sides in the UKA group were significantly lower for the knee flexion and adduction moments when compared with the unoperated side and were most prevalent during the loading phase. Conclusions These results are relevant in terms of prosthesis wear. The TKA knees had smaller magnitude moments than the UKA knees in the sagittal and coronal planes. This could explain the higher revision rates for UKA. In both groups, the non-operated knees had significantly larger moments than the operated knees, which implies that after unilateral knee replacement of either type, the non-operated knee is being put under greater stress.