Circulating fluidized bed downer reactors (downer reactors) exhibit good heat and mass transfer, and the flow behavior approaches the ideal plug flow.

No abstract

Stirred tanks are prevalent in various industries, including chemical, biochemical, and pharmaceutical industries. These reactors are suitable for ensuring efficient mass and heat transfer because adequate mixing can be achieved. Numerous studies have been conducted on small-scale stirred-tank reactors. However, upscaling such reactors is challenging because of the complex flow behavior inside the system, especially for the mixing of immiscible liquid–liquid systems. Thus, the objectives of this study were to examine the flow behavior and upscale an immiscible liquid–liquid stirred tank using CFD simulation by investigating a flat-bottomed stirred tank reactor, equipped with a six-blade Rushton turbine. The simulated results were in good agreement with those obtained experimentally. The scale of the reactor significantly affects the hydrodynamic behavior, and the uniformity of the radial distribution of the velocity decreases with increasing Reynolds number. Furthermore, the upscaling criteria were evaluated for geometric similarity and equal mixing times. The proposed scaling law reliably scaled up the immiscible liquid–liquid mixing in a stirred tank with a difference in the range of ±10%.

Because of the continuous increase in the amount of plastic waste, catalytic cracking is an interesting method that could be used to convert heavy oil from thermal cracking of plastic waste into fuel. The objective of this study was to investigate the hydrodynamic behavior and the performance of catalytic cracking of heavy oil in a circulating fluidized bed reactor using computational fluid dynamics. The two– fluid model incorporated with the kinetic theory of granular flow was applied to predict the hydrodynamic behavior with a reactive flow. Three reactor geometries were studied, which included a conventional riser, tapered–out riser, and tapered–in riser. The four–lump kinetic model was used to describe the catalytic cracking of heavy oil from waste plastic. A core–annulus flow pattern was found in the three reactor geometries. The solid fraction distribution of the tapered reactor was found to be more uniform than that of the conventional riser. The tapered–in riser showed the highest heavy oil conversion with the lowest gasoline selectivity. However, the heavy oil conversion and gasoline selectivity of the conventional and tapered–out reactors were not significantly different.

No abstract