No abstract

Triply periodic minimal surface (TPMS) structures with high surface area, high porosity, complex pore channels, and pore size distribution have great potential for application in thermal metamaterials and thermal engineering applications. To demonstrate the possibility of the use of TPMS structures as thermal metamaterials, the thermal insulation properties and heat transfer mechanisms of TPMS structures are investigated in detail. The results show that modulation of the volume fraction to within 15% by a rational geometric design indicates the possibility to obtain excellent lightweight properties. The effective thermal conductivity is within 0.25 W m−1 K−1, which is much lower than this component, indicating that the TPMS structure is designed to reduce the effective thermal conductivity and provide a lightweight design. However, in a high‐temperature environment, reasonable structural parameters can shield the cavity radiation in the TPMS structure and play an effective role to provide high‐temperature thermal insulation. Finally, based on the relationship between structural parameters and thermal insulation performance, a dynamic density TPMS‐graded structure is proposed, which exhibits a better thermal insulation performance than the conventional TPMS structure both at room temperature and at high temperature.

Vat photopolymerization (VPP) presents new opportunities for metals to achieve the design freedom of components. However, the material properties of copper powder and the inherent defects of the technology seriously hinder its application in high-precision metal additive manufacturing. Precision control is the key to obtaining minimal precision metal parts when copper is prepared by reduction photopolymerization. This paper employed variance analysis (ANOVA) and root mean square deviation (RMSD) to determine the significant parameters affecting dimensional accuracy and their optimal regions. The results show that printing accuracy is improved by optimizing exposure time, intensity, layer thickness, and sweeper moving speed. When the exposure time is 21 s, and the exposure intensity is 220 mW/cm2, a hole with a height of 1 mm and a diameter of 200 μm can be printed with a minimum size deviation of 51 μm. In addition, RMSD and ANOVA provide an effective method for realizing high-precision stereolithography 3D printing metal copper, expanding the material adaptation in the 3D printing metals field. The study highlights the potential of VPP as a method for preparing metals in future studies.