Centerline segregation is an inherent phenomenon during solidification. It is controlled by optimizing the continuous casting process, but is not easy to be avoided. According to the severity of centerline segregation of the slab, it affects the mechanical properties and final microstructure of rolled strip. The objective of this paper is to study the influence of centerline segregation degree on the microstructure and mechanical properties of X70 pipeline steels. In this study, the mechanical properties of strips produced from the slabs are examined and the results show that centerline segregation is some adverse effect on Charpy impact toughness and tensile properties of hot‐rolled strips. The strips from slab with higher degree of segregation, exhibits lower Charpy impact toughness, higher tensile strength, higher microhardness. The segregated degree of slab is studied by using the method of Mannesmann, indicating that it could be up to class 3–4. Moreover, the results from Electron Probe Micro Analyzer (EPMA) shows that high level of Mn content is obtained at the centerline of strips processed from the slab with segregation degree of class 3–4. The corresponding microstructure is identified as lath martensite, which should be contributed to the undesirable mechanical properties.

Low variability in mechanical properties is required for pipeline project designs to meet a strain-based design, which is used in regions of large ground movements. The objective of this study is to elucidate the influence of centerline segregation in continuously cast slab on variability in the mechanical property of pipeline steel, and controlling centerline segregation can meet the requirements of a strain-based design. Mannesmann rating method was used to evaluate the degree of segregation of two slabs and its effect on variability in mechanical properties of corresponding plates. Microstructural characterization indicated that bainite/martensite was formed in a segregated area where the content of C and Mn enriched. The mechanical property results indicated that controlling the degree of centerline segregation can reduce tensile strength variability and improve ductile-brittle transition temperature (DBTT).

The dissolution behavior of carbides in martensitic stainless steel and its effect on microstructure and hardness were investigated by using X-ray diffractometer (XRD) and field emission scanning electron microscopy (FE-SEM) with energy dispersive spectrometer (EDS) and electron backscattering diffraction (EBSD). The results indicated that the microstructure after austenitizing heat treatment and oil quenched consisted of martensite, M23C6 carbides and retained austenite. The temperature and particle size had great influence on the dissolution of carbides. The EBSD results showed that the twin-related variant pair V1/V2 governed the phase transformation. Meanwhile, the density of high-angle grain boundaries (HAGBs) increased with the increase of austenitizing temperature from 950 to 1150 °C. The hardness test results indicated that the hardness first increased and then decreased with the increase of the austenitizing temperature, and the peak appeared at 1050 °C with a Rockwell hardness value of 59.8 HRC. A model was established to quantitatively explain the contribution of different microstructures to hardness. The contribution to hardness came mainly from martensite. The retained austenite had a negative effect on hardness when the volume fraction was more than 10%. In contrast, carbides contributed less to hardness due to their small content.

No abstract