In a charge-coupled device (CCD)-based fast steering mirror (FSM) tracking control system, high control bandwidth is the most effective way to enhance the closed-loop performance. However, the control system usually suffers a great deal from mechanical resonances and time delays induced by the low sampling rate of CCDs. To meet the requirements of high precision and load restriction, fiber-optic gyroscopes (FOGs) are usually used in traditional FSM tracking control systems. In recent years, the MEMS accelerometer and gyroscope are becoming smaller and lighter and their performance have improved gradually, so that they can be used in a fast steering mirror (FSM) to realize the stabilization of the line-of-sight (LOS) of the control system. Therefore, a tentative approach to implement a CCD-based FSM tracking control system, which uses MEMS accelerometers and gyroscopes as feedback components and contains an acceleration loop, a velocity loop and a position loop, is proposed. The disturbance suppression of the proposed method is the product of the error attenuation of the acceleration loop, the velocity loop and the position loop. Extensive experimental results show that the MEMS accelerometers and gyroscopes can act the similar role as the FOG with lower cost for stabilizing the LOS of the FSM tracking control system.

, "Inertial sensor-based multiloop control of fast steering mirror for line of sight stabilization," Opt. Eng. 55 (11) Abstract. In the charge-coupled device (CCD)-based tracking control system of fast steering mirrors (FSMs), high control bandwidth is the most effective method to enhance closed-loop performance, which, however, usually suffers a great deal from time delay induced by a low CCD sampling rate. Moreover, mechanical resonances also limit high control bandwidth. Therefore, a tentative approach to implementing a CCD-based tracking control system for an FSM with inertial sensor-based cascade feedback is proposed, which is made up of acceleration feedback, velocity feedback, and position feedback. Accelerometers and gyroscopes are all the inertial sensors, sensing vibrations induced by platforms, in turn, which can contribute to disturbance supersession. In theory, the acceleration open-loop frequency response of the FSM includes a quadratic differential, and it is very difficult to compensate a quadratic differential with a double-integral algorithm. A lag controller is used to solve this problem and accomplish acceleration closed-loop control. The disturbance suppression of the proposed method is the product of the error attenuation of the acceleration loop, the velocity loop, and the position loop. Extensive experimental results show that the improved control mode can effectively enhance the error attenuation performance of the line of sight (LOS) for the CCD-based tracking control system.

The aim of this paper is to present a sensor fault-tolerant control (FTC) scheme for a two-axis fast steering mirror (FSM) system with minimum power consumption and without changing the controller structure. In this paper, an adaptive PI-based sliding mode observer (APISMO) is adopted firstly to estimate the fault signal, which does not require any prior knowledge of the fault. The estimation is then used by the fault isolation logic to identify the fault. The redundant sensor would be powered up to replace the faulty one when faults occur. During the backup sensor booting up, for maintaining the normal performance of the closed-loop system approximately, a fault-free estimation of the position provided by the APISMO is used as feedback signal. Experimental studies on a prototype system show that the proposed APISMO can effectively reconstruct the fault signals even when the two primary position sensors are faulty simultaneously. Meanwhile, the effectiveness and performance of the proposed scheme have been verified.