The use of molasses as a replacement for bitumen could benefit the pavement industry by improving the performance of the pavement or by lowering its cost. An experimental investigation was carried out to investigate the effect of molasses with different moisture contents on the property of hot-mix asphalt (HMA). Bitumen binders (BB) containing 5%, 10%, 15%, and 20% molasses were investigated as molasses modified binders (MMB). Molasses with 24.9% and 5.02% by weight of water were used to investigate the effect of moisture on the MMBs. In addition to the conventional binder tests, additional tests such as the Fourier transform infrared (FTIR) test, amplitude and frequency sweep test, performance grade (PG) test, and multiple stress creep recovery (MSCR) test were performed. The results indicated that most of the properties of the MMBs improved with the reduction in the moisture content of molasses but worsened with the percentage replacement of molasses. The IR spectra show that the carbonyl index decreased with an increasing amount of molasses. The control grade PG58 was improved to PG64 and PG70 when the base binder was modified with molasses and aged with rolling thin film oven (RTFO) consecutively. At a temperature of 58 °C, non-recoverable creep compliance of 3.2 kPa (Jnr3.2kPa) was decreased for each MMB, which leads to improved rutting potential. At a temperature of 64 °C, the Jnr value was decreased only for the MMB containing 5% molasses, and then gradually increased for the remaining MMBs. Generally, the study revealed that low moisture content molasses could be used as a partial replacement for bitumen to enhance the rheological properties of the bitumen.

The high volume of water in molasses has made this study serious. The reason is that using molasses as a partial replacement without treatment significantly affects the rheological properties of the neat bitumen and increases the likelihood of moisture susceptibility of the hotmix asphalt (HMA) pavement structure and create fractures of aggregate particles. Therefore, to use molasses as a partial replacement without affecting the structural integrity of the pavement, this study proposed a treatment method before blending it with petroleum-based bitumen. A series of experiment was conducted to accomplish the objective of this paper, including convectional tests, Fourier transform infrared (FTIR) test, amplitude and frequency sweep test, performance grade (PG) determination test, and multiple stress creep recovery (MSCR) tests. The IR spectra show that carbonyl index decreased with increasing molasses percent. There was PG improvement from the control grade to PG64 and PG70 when the base binder modified with 5-20% molasses and aged with rollingl thin film oven (RTFO) respectively. At the temperature 58 o C nonrecoverable creep compliance at 3.2 kPa (Jnr3.2kPa) was decreased for each percent replacement. This led to improving the rutting potential. As well, at a temperature of 64 o C the Jnr value was decreased only for 5% replacement, and then the Jnr value was gradually increased for the remaining percent replacement. Overall, this study revealed that treated molasses can be used as a partial replacement to enhance the rheological properties of the base bitumen and thus it can potentially be used to produce a sustainable bio-asphalt binder.