The molecular composition of secondary organic aerosol (SOA) from the ozonolysis of monoterpenes (α-pinene and β-pinene) was studied by liquid chromatography mass spectrometry and high-resolution Fourier transform ion cyclotron resonance mass spectrometry techniques, both employing electrospray ionization (ESI). SOA particles were generated in a flow tube reactor with a reaction time of 23 s. A microsampling assembly in combination with ESI-FTICR analysis permitted SOA with a mass loading as low as 3.5 μg/m(3) to be characterized with high accuracy and precision mass analysis. Hundreds of product molecular formulas were identified that were common to all mass loadings; however the relative intensities changed significantly. In particular, a species with the (neutral molecule) formula C(17)H(26)O(8) increased substantially in intensity relative to other products as the mass loading decreased. Tandem mass spectrometry (MS(n)) of this species showed it to be a dimer of C(9)H(14)O(4) and C(8)H(12)O(4), most likely pinic acid and terpenylic acid, respectively. LCMS analysis showed different elution times for the dimer and monomer species, confirming that the dimer was not an artifact of ESI analysis. The particle number concentration increased linearly with ozone concentration (the limiting reactant in the experiment), arguing against gas phase dimerization as the rate limiting step in particle formation.

The composition and structure of freshly formed oligomers in alpha- and beta- pinene SOA are studied with high performance mass spectrometry to provide insight into the SOA formation mechanism. Van Krevelen plots (H:C ratio vs O:C ratio) are interpreted in the context of distinct structural domains that correspond to separate oligomer formation routes. The domain containing most of the signal intensity encompasses elemental formulas that correspond to oligomerization reactions of intermediates and/or stable molecule monomers produced by ozonolysis of the precursor. While oligomers involving reactive intermediates from the hydroperoxide channel dominate the product distribution, products are also observed that uniquely map to the stable Criegee intermediate and/ or combinations of stable molecule monomers. A second domain encompasses molecules having lower H:C ratios but similar O:C ratios to the first domain. Many of the products observed in this domain have double bond equivalents greater than the maximum number possible when forming dimers by standard reaction mechanisms and are interpreted in the context of repeated self-reactions of alkoxy/peroxy radicals. A third domain encompasses molecules having very high H:C and O:C ratios consistent with polymerization of formaldehyde and/or acetaldehyde. These domains remain distinguishable from experiment to experiment and among different extraction solvents (50/50 methanol-water, 50/50 acetonitrile-water,100% water).

The quantity, extraction efficiency, and molecular composition of non-volatile oligomeric species in SOA generated by the reaction of α-pinene with ozone were studied. Two different methods of determining the total particulate mass in the reaction chamber were compared and found to be in good agreement when changes in the partitioning of semi-volatile compounds to the particle phase during measurement were properly handled. Almost all of the nonvolatile organic carbon formed by the reaction was collected and recovered by extraction with organic solvents; recoveries with water extraction were somewhat lower. The identities of compounds extracted by the various solvents were determined using electrospray ionization Fourier transform ion cyclotron resonance (ESI-FTICR) mass spectrometry. Over 80% of the peaks weighted by mass and intensity were the same in the spectra of samples obtained from different extraction solvents. Standard addition plots were used to determine the amounts of two commercially available monomer compounds in the SOA extracts. When the response factors for those compounds were applied to other monomers detected in the mass spectra, the weight percent of monomers was estimated to be slightly less than 50%, with the remaining mass (over 50%) assigned to oligomers. The oligomer content is sufficiently large that it should be taken into account when modeling the formation and properties of laboratory SOA.

Secondary organic aerosol (SOA) is formed when organic molecules react with oxidants in the gas phase to form particulate matter. Recent measurements have shown that more than half of the mass of laboratory-generated SOA consists of high molecular weight oligomeric compounds. In this work, the formation mechanisms of oligomers produced in the laboratory by ozonolysis of α-pinene, an important SOA precursor in ambient air, are studied by MS and MS/MS measurements with high accuracy and resolving power to characterize monomer building blocks and the reactions that couple them together. The distribution of oligomers in an SOA sample is complex, typically yielding over 1000 elemental formulas that can be assigned from an electrospray ionization mass spectrum. Despite this complexity, MS/MS spectra can be found that give strong evidence for specific oligomer formation pathways that have been postulated but not confirmed. These include aldol and gem-diol reactions of carbonyls as well as peroxyhemiacetal formation from hydroperoxides. The strongest evidence for carbonyl reactions is in the formation of hydrated products. Less compelling evidence is found for dehydrated products and secondary ozonide formation. The number of times that a monomer building block is observed as a fragmentation product in the MS/MS spectra is shown to be independent of the monomer vapor pressure, suggesting that oligomer formation is not driven by equilibrium partitioning of a monomer between the gas and particle phases, but rather by reactive uptake where a monomer collides with the particle surface and rapidly forms an oligomer.