No abstract

No abstract

Digitalization offers new, unprecedented possibilities to increase the energy efficiency and improve the indoor conditions in buildings in a cost-efficient way. Smart buildings are seen by many stakeholders as the way forward. Smart buildings feature advanced monitoring and control systems that allow a better control of the buildings’ indoor spaces, but it is becoming evident that the massive amount of data produced in smart buildings is rarely used. This work presents a long-term evaluation of a smart building testbed for one year; the building features state-of-the-art monitoring capability and local energy generation (PV). The analysis shows room for improving energy efficiency and indoor comfort due to non-optimal control settings; for instance, average indoor temperatures in all winter months were above 24 °C. The analysis of electricity and domestic hot water use has shown a relevant spread in average use, with single users consuming approximately four times more than the average users. The combination of CO2 and temperature sensor was sufficient to pinpoint the anomalous operation of windows in wintertime, which has an impact on energy use for space heating. Although the quantification of the impact of users on the overall energy performance of the building was beyond the scope of this paper, this study showcases that modern commercial monitoring systems for buildings have the potential to identify anomalies. The evidence collected in the paper suggests that this data could be used to promote energy-efficient behaviors among building occupants and shows that cost-effective actions could be carried out if data generated by the monitoring and control systems were used more extensively.

No abstract

Raman-based distributed temperature sensing (DTS) is a valuable tool for field testing and validating heat transfer models in borehole heat exchanger (BHE) and ground source heat pump (GSHP) applications. However, temperature uncertainty is rarely reported in the literature. In this paper, a new calibration method was proposed for single-ended DTS configurations, along with a method to remove fictitious temperature drifts due to ambient air variations. The methods were implemented for a distributed thermal response test (DTRT) case study in an 800 m deep coaxial BHE. The results show that the calibration method and temperature drift correction are robust and give adequate results, with a temperature uncertainty increasing non-linearly from about 0.4 K near the surface to about 1.7 K at 800 m. The temperature uncertainty is dominated by the uncertainty in the calibrated parameters for depths larger than 200 m. The paper also offers insights into thermal features observed during the DTRT, including a heat flux inversion along the borehole depth and the slow temperature homogenization under circulation.