ABSTRACT. We provide an assessment of the supraglacial water budget of a moulin basin on the western margin of the Greenland ice sheet for 15 days in August 2009. Meltwater production, the dominant input term to the 1.14 AE 0.06 km 2 basin, was determined from in situ ablation measurements.The dominant water-output terms from the basin, accounting for 52% and 48% of output, respectively, were moulin discharge and drainage into crevasses. Moulin discharge exhibits large diurnal variability (0.017-0.54 m 3 s -1) with a distinct late-afternoon peak at 16:45 local time. This lags peak meltwater production by $2.8 AE 4.2 hours. An Extreme Ice Survey time-lapse photography sequence complements the observations of moulin discharge. We infer, from in situ observations of moulin geometry, previously published borehole water heights and estimates of the temporal lag between meltwater production and observed local ice surface uplift ('jacking'), that the transfer of surface meltwater to the englacial water table via moulins is nearly instantaneous (<30 min). We employ a simple crevasse mass-balance model to demonstrate that crevasse drainage could significantly dampen the surface meltwater fluctuations reaching the englacial system in comparison to moulin discharge. Thus, unlike crevasses, moulins propagate meltwater pulses to the englacial system that are capable of overwhelming subglacial transmission capacity, resulting in enhanced basal sliding.

The surface snow density of glaciers and ice sheets is of fundamental importance in converting volume to mass in both altimetry and surface mass balance studies, yet it is often poorly constrained. Site-specific surface snow densities are typically derived from empirical relations based on temperature and wind speed. These parameterizations commonly calculate the average density of the top meter of snow, thereby systematically overestimating snow density at the actual surface. Therefore, constraining surface snow density to the top 0.1 m can improve boundary conditions in high-resolution firn-evolution modeling. We have compiled an extensive dataset of 200 point measurements of surface snow density from firn cores and snow pits on the Greenland ice sheet. We find that surface snow density within 0.1 m of the surface has an average value of 315 kg m −3 with a standard deviation of 44 kg m −3 , and has an insignificant annual air temperature dependency. We demonstrate that two widely-used surface snow density parameterizations dependent on temperature systematically overestimate surface snow density over the Greenland ice sheet by 17-19%, and that using a constant density of 315 kg m −3 may give superior results when applied in surface mass budget modeling.

ABSTRACT. We apply a novel one-dimensional glacier hydrology model that calculates hydraulic head to the tidewater-terminating Sermeq Avannarleq flowline of the Greenland ice sheet. Within a plausible parameter space, the model achieves a quasi-steady-state annual cycle in which hydraulic head oscillates close to flotation throughout the ablation zone. Flotation is briefly achieved during the summer melt season along a $ $17 km stretch of the $50 km of flowline within the ablation zone. Beneath the majority of the flowline, subglacial conduit storage 'closes' (i.e. obtains minimum radius) during the winter and 'opens' (i.e. obtains maximum radius) during the summer. Along certain stretches of the flowline, the model predicts that subglacial conduit storage remains open throughout the year. A calculated mean glacier water residence time of $2.2 years implies that significant amounts of water are stored in the glacier throughout the year. We interpret this residence time as being indicative of the timescale over which the glacier hydrologic system is capable of adjusting to external surface meltwater forcings. Based on in situ ice velocity observations, we suggest that the summer speed-up event generally corresponds to conditions of increasing hydraulic head during inefficient subglacial drainage. Conversely, the slowdown during fall generally corresponds to conditions of decreasing hydraulic head during efficient subglacial drainage.