No abstract

No abstract

It is widely accepted that volumetric contraction and solidification during the polymerization process of restorative composites in combination with bonding to the hard tissue result in stress transfer and inward deformation of the cavity walls of the restored tooth. Deformation of the walls decreases the size of the cavity during the filling process. This fact has a profound influence on the assumption--raised and discussed in this paper--that an incremental filling technique reduces the stress effect of composite shrinkage on the tooth. Developing stress fields for different incremental filling techniques are simulated in a numerical analysis. The analysis shows that, in a restoration with a well-established bond to the tooth--as is generally desired--incremental filling techniques increase the deformation of the restored tooth. The increase is caused by the incremental deformation of the preparation, which effectively decreases the total amount of composite needed to fill the cavity. This leads to a higher-stressed tooth-composite structure. The study also shows that the assessment of intercuspal distance measurements as well as simplifications based on generalization of the shrinkage stress state cannot be sufficient to characterize the effect of polymerization shrinkage in a tooth-restoration complex. Incremental filling methods may need to be retained for reasons such as densification, adaptation, thoroughness of cure, and bond formation. However, it is very difficult to prove that incrementalization needs to be retained because of the abatement of shrinkage effects.

The integration of two closed mechanical loops was used to produce a force-movement cycle, using servo-hydraulics. Several of the parameters were of interest in clinically-simulated laboratory studies. The system represented the first phase in developing an artificial oral environment.

It is widely accepted that a dentin shear bond test which pulls out dentin must mean that the adhesive strength is superior to the cohesive strength of the dentin. Using numerical modeling techniques, Van Noort et al. (1988, 1989) and DeHoff et al. (1995) alerted the scientific community that there were massive stress concentrations in the familiar dentin bond test. It is not inconceivable that these localized high tensile stresses could initiate cracks which diverge monolithically into dentin, leaving the interface unchallenged. To test this hypothesis, we developed a failure accumulation simulation program which determined localized failure interactively "on the fly" with a finite element solver, and also included brittle behavior, adhesive and cohesive failure, stochastic response, and dynamic remeshing. All of the familiar dentin bond variables were included in the simulation. A parallel experimental dentin bond test validation was run, and the fractography was examined in the scanning electron microscope for mode of failure. The simulation confirmed the tensile monolithic fracture hypothesis. It is also confirmed that dentin pull-out was partly due to the biomechanics of the test and did not necessarily mean superior adhesive strength or even that the cohesive strength of the dentin was reduced. There is clear need for a new technology for the evaluation of biological interfaces, and the present work has shown the vital role of numerical modeling in the interpretation of such experimental procedures.