A novel pH and temperature sensitive block copolymer was prepared by adding pH sensitive moiety to temperature sensitive block copolymer. This block copolymer solution showed a reversible sol-gel transition by a small pH change in the range of pH 7.4-8.0 and also by the temperature change in the region of body temperature. The very precise molecular weight control of block copolymer and the prudential tuning of hydrophilic-hydrophobic balance were needed to control the phase diagram. This block copolymer solution forms a gel at 37 degrees C, pH 7.4 (human body). When the block copolymer solution is at room temperature and pH 8.0 as a sol state, both the temperature and pH change are needed for the gelation. This material can be employed as injectable carriers for hydrophobic drugs and proteins, etc. Gelation inside the needle can be prevented by an increase in the temperature during injection, because it does not change into the gel form with only increasing temperature. This material can be used for even a long guide catheter into the body. The block copolymer hydrogel which shows the sol-gel transition by the small pH change from pH 8.0 to pH 7.4 has merits in the delivery system for protein and cells which show cytotoxicity in acidic (below pH 6.5) or basic (above pH 8.5) conditions. This block copolymer system could be used as a template technology for injectable delivery systems.

Novel thermoreversible gelation behavior of aqueous solutions of ABA-type triblock copolymers composed of the central polyethylene oxide (PEG) block and two poly(D,L-lactic acid-co-glycolic acid) side blocks was found. Phase transition characteristics, such as critical gel concentration (CGC) and lower and upper critical gel temperature (CGT), are closely related to the molecular structure of the triblock copolymers. The CGC and the lower CGT both increases with increasing PEG/PLGA molecular weight ratio. Increasing the GA content in PLGA block induces a somewhat higher CGC. The copolymer forms micelles with a PLGA loop core and a PEG shell in water. Also grouped micelles are identified seemingly due to the bridging of two micelles sharing two PLGA blocks of a block copolymer chain. As the temperature increases the association of micelles increases, which results in gelation. The ABA-type copolymers exhibit a relatively low CGC (<10%) and low sol-gel transition temperatures compared to BAB-type copolymers. As the temperature increases further gel-sol transition is observed, which would result from the shrinkage of micelles with temperature increase. The hydrodynamic size of the micelles is monitored by dynamic laser scattering, and a possible gelation mechanism was suggested.

Novel pH- and temperature-sensitive biodegradable poly(epsilon-caprolactone-co-lactide)-poly(ethylene glycol) (PCLA-PEG) block copolymers were synthesized with oligomeric sulfamethazine (OSM) end groups (OSM-PCLA-PEG-PCLA-OSM). Aqueous solutions of these block copolymers have shown sol-gel transition behavior upon both temperature and pH changes under physiological conditions (37 degrees C, pH 7.4). The sol-gel transition of these block copolymer solutions was fine-tuned by controlling the PEG length, the hydrophobic to hydrophilic block ratio (PCLA/PEG), and the molecular weight of the sulfamethazine oligomer. Since changes in temperature do not induce gel formation in this pH- and temperature-sensitive block copolymer solution, this hydrogel can be employed as an injectable carrier using a long guide catheter into the body. In addition, the pH of the block copolymer solution showed no change following PCLA degradation over 1 month, and no indication of gel collapse was observed on addition of buffer solution. As such, these properties make the OSM-PCLA-PEG-PCLA-OSM hydrogel an ideal candidate for use as an injectable carrier for certain protein-based drugs known to denature in low-pH environments.