The turbine blade is one of the most critical components of a steam turbine. The high thermal loads and large centrifugal forces cause extreme stresses on the blade, especially on its root. This paper focuses on improving the double-T root of a turbine blade of the control stage by decreasing the root’s peak equivalent von-Mises stress. An 18% reduction was achieved in the peak stress by changing the convexity of the contact surface between the root and the groove. The equivalent von-Mises stress was determined in a static structural analysis of a three dimensional finite element model (3D FEM-model) using ANSYS Workbench. This numerical model was developed to include one blade and the associated part of the shaft, whereas the complete circle of blades was considered by applying cyclic symmetry. Furthermore, this paper includes a modal analysis comparing the natural frequencies of the initial FEM-model with the frequencies of the optimized one. The results were established by an investigation of the influence of the FEM-model’s parameters, its material properties, thermal effects, and an additional damping wire in the shroud.