Microbial desalination cell (MDC) is a new method to obtain clean water from brackish water using electricity generated from organic matters by exoelectrogenic bacteria. Anions and cations, derived from salt solution filled in the desalination chamber between the anode and cathode, move to the anode and cathode chambers under the force of electrical field, respectively. On the basis of the primitive single-desalination-chambered MDC, stacked microbial desalination cells (SMDCs) were developed in order to promote the desalination rate in the present study. The effects of desalination chamber number and external resistance were investigated. Results showed that a remarkable increase in the total desalination rate (TDR) could be obtained by means of increasing the desalination cell number and reducing the external resistance, which caused the charge transfer efficiency increased since the SMDCs enabled more pairs of ions separated while one electron passed through the external circuit. The maximum TDR of 0.0252 g/h was obtained using a two-desalination-chambered SMDC with an external resistance of 10 Ω, which was 1.4 times that of single-desalination-chambered MDC. SMDCs proved to be an effective approach to increase the total water desalination rate if provided a proper desalination chamber number and external resistance.

Solar-thermal evaporation is a promising technology for energy-efficient desalination, but salt accumulation on solar absorbers and system longevity are major challenges that hinder its widespread application. In this study, we...

Wastewater contains significant amounts of nitrogen that can be recovered and valorized as fertilizers and chemicals. This study presents a new membrane electrode coupled with microbial electrolysis that demonstrates very efficient ammonia recovery from synthetic centrate. The process utilizes the electrical potential across electrodes to drive NH ions toward the hydrophilic nickel top layer on a gas-stripping membrane cathode, which takes advantage of surface pH increase to realize spontaneous NH production and separation. Compared with a control configuration with conventionally separated electrode and hydrophobic membrane, the integrated membrane electrode showed 40% higher NH-N recovery rate (36.2 ± 1.2 gNH-N/m/d) and 11% higher current density. The energy consumption was 1.61 ± 0.03 kWh/kgNH-N, which was 20% lower than the control and 70-90% more efficient than competing electrochemical nitrogen recovery processes (5-12 kWh/kgNH-N). Besides, the negative potential on membrane electrode repelled negatively charged organics and microbes thus reduced fouling. In addition to describing the system's performance, we explored the underlying mechanisms governing the reactions, which confirmed the viability of this process for efficient wastewater-ammonia recovery. Furthermore, the nickel-based membrane electrode showed excellent water entry pressure (∼41 kPa) without leakage, which was much higher than that of PTFE/PDMS-based cathodes (∼1.8 kPa). The membrane electrode also showed superb flexibility (180° bend) and can be easily fabricated at low cost (<20 $/m).

Current membrane distillation (MD) is challenged by the inefficiency of water thermal separation from dissolved solutes, controlled by membrane porosity and thermal conductivity. Existing petroleum-derived polymeric membranes face major development barriers. Here, we demonstrate a first robust MD membrane directly fabricated from sustainable wood material. The hydrophobic nanowood membrane had high porosity (89 ± 3%) and hierarchical pore structure with a wide pore size distribution of crystalline cellulose nanofibrils and xylem vessels and lumina (channels) that facilitate water vapor transportation. The thermal conductivity was extremely low in the transverse direction, which reduces conductive heat transport. However, high thermal conductivity along the fiber enables efficient thermal dissipation along the axial direction. As a result, the membrane demonstrated excellent intrinsic vapor permeability (1.44 ± 0.09 kg m−1 K−1 s−1 Pa−1) and thermal efficiency (~70% at 60°C). The properties of thermal efficiency, water flux, scalability, and sustainability make nanowood highly desirable for MD applications.