Arrayed three-dimensional (3D) micro-sized tissues with encapsulated cells (microtissues) have been fabricated by a droplet microfluidic chip. The extracellular matrix (ECM) is a polymerized collagen network. One or multiple breast cancer cells were embedded within the microtissues, which were stored in arrayed microchambers on the same chip without ECM droplet shrinkage over 48 h. The migration trajectory of the cells was recorded by optical microscopy. The migration speed was calculated in the range of 3–6 µm/h. Interestingly, cells in devices filled with a continuous collagen network migrated faster than those where only droplets were arrayed in the chambers. This is likely due to differences in the length scales of the ECM network, as cells embedded in thin collagen slabs also migrate slower than those in thick collagen slabs. In addition to migration, this technical platform can be potentially used to study cancer cell-stromal cell interactions and ECM remodeling in 3D tumor-mimicking environments.

No abstract

Cells communicate through the extracellular matrix (ECM) in many physiological and pathological processes. This is particularly important during cell migration, where cell communication can alter both the speed and the direction of migration. However, most cell culture systems operate with large volumes relative to cell numbers, creating low cell densities and diluting factors that mediate cell communication. Furthermore, they lack the ability to isolate single cells or small groups of cells. Droplet forming devices allow for an ability to embed single or small groups of cells into small volume segregated 3D environments, increasing the cell density to physiological levels. In this paper we show a microfluidic droplet device for fabricating 3D collagen-based microtissues to study breast cancer cell motility. MDA-MB-231 cells fail to spread and divide in small, thin chambers. Cell migration is also stunted as compared to thick 3D gels. However, larger chambers formed by a thicker devices promote cell spreading, cell division and faster migration. In the large devices, both cell-ECM and cell-cell interactions affect cell motility. Increasing collagen density decreases cell migration and increasing the number of cells per chamber increases cell migration speed. Furthermore, cells appear to sense both the ECM-chamber wall interface as well as other cells. Cells migrate towards the ECM-chamber interface if within roughly 150 μm, whereas cells further than 150 μm tend to move towards the center of the chamber. Finally, while cells do not show enhanced movement towards the center of mass of a cell cluster, their migration speed is more variable when further away from the cell cluster center of mass. These results show that microfluidic droplet devices can array 3D collagen gels and promote cell spreading, division and migration similar to what is seen in thick 3D collagen gels. Furthermore, they can provide a new avenue to study cell migration and cell-cell communication at physiologically relevant cell densities.

In this paper, a drug loading and release device fabricated using nanopore thin film and layer-by-layer (LbL) nanoassembly is reported. The nanopore thin film is a layer of anodic aluminum oxide (AAO), consisting of honeycomb-shape nanopores. Using the LbL nanoassembly process, the drug, using gentamicin sulfate (GS) as the model, can be loaded into the nanopores and the stacked layers on the nanopore thin film surface. The drug release from the device is achieved by immersing it into flowing DI water. Both the loading and release processes can be monitored optically. The effect of the nanopore size/volume on drug loading and release has also been evaluated. Further, the neuron cells have been cultured and can grow normally on the nanopore thin film, verifying its bio-compatibility. The successful fabrication of nanopore thin film device on silicon membrane render it as a potential implantable controlled drug release device.