No abstract

Effective biofilm inactivation using a handheld, mobile plasma jet powered by a 12 V dc battery and operated in open air without any external gas supply is reported. This cold, room-temperature plasma is produced in self-repetitive nanosecond discharges with current pulses of ∼100 ns duration, current peak amplitude of ∼6 mA and repetition rate of ∼20 kHz. It is shown that the reactive plasma species penetrate to the bottom layer of a 25.5 µm-thick Enterococcus faecalis biofilm and produce a strong bactericidal effect. This is the thickest reported biofilm inactivated using room-temperature air plasmas.

Atmospheric pressure plasma jets (APPJs) have attracted considerable attention over the last decade, specifically for use in surface engineering. A comparative study of an APPJ, driven by pulsed DC voltage, is conducted in order to examine the plasma impingement onto different surfaces. In this paper, the effect of gas flow rate and composition is investigated using three kinds of substrates: dielectric glass, distilled water and metal plate using fast imaging. Alongside discharges associated with rising and falling voltage, a so-called third discharge is observed during the pulse for water and metal surfaces which corresponds to a restrike breakdown from surfaces to nozzle. The differences in plasma dynamics observed are mainly attributed to the differences in substrate conductivity. In addition, spatial and temporal distributions of OH and O density are investigated by means of laser induced fluorescence (LIF). The OH/O LIF intensity is found to be much higher for metal and water substrates compared to the glass plate. We attribute this effect to the differences in power dissipation associated with the presence and intensity of the third discharge. Effects of gas flow rate and seed gas (H 2 O and O 2 ) mixing on the LIF enhancement are also studied. The related results provide additional insights for optimizing the generation of reactive species.

We report on factors influencing the specific energy costs of producing NO x from pin-to-pin DC glow discharges in air at atmospheric pressure. Discharge current, gap distance, gas flowrate, exterior tube wall temperature and the presence and position of activated Al2O3 catalyst powder were examined. The presence of heated catalyst adjacent to the plasma zone improved energy efficiency by as much as 20% at low flows, but the most energy efficient conditions were found at the highest flowrates that allowed a stable discharge (about 10–15 l min−1). Under these conditions, the catalyst had no effect on efficiency in the present study. The lowest specific energy cost was observed to be between about 200–250 GJ/tN. The transport of active chemical species and energy are likely key factors controlling the specific energy costs of NO x production in the presence of a catalyst. Air plasma device design and operating conditions must ensure that plasma-generated active intermediate chemical species transport is optimally coupled with catalytically active surfaces.