No abstract

No abstract

No abstract

Microstructure-based constitutive models for multiphase steels require accurate constitutive properties of the individual phases for component forming and performance simulations. We address this requirement with a combined experimental/theoretical methodology which determines the critical resolved shear stresses and hardening parameters of the constituent phases in QP980, a TRIP assisted steel subject to a two-step quenching and partitioning heat treatment. High energy X-Ray diffraction (HEXRD) from a synchrotron source provided the average lattice strains of the ferrite, martensite, and austenite phases from the measured volume during in situ tensile deformation. The HEXRD data was then input to a computationally efficient, elastic-plastic self-consistent (EPSC) crystal plasticity model which estimated the constitutive parameters of different slip systems for the three phases via a trial-and-error approach. The EPSC-estimated parameters are then input to a finite element crystal plasticity (CPFE) model representing the QP980 tensile sample. The predicted lattice strains and global stress versus strain curves are found to be 8% lower that the EPSC model predicted values and from the HEXRD measurements, respectively. This discrepancy, which is attributed to the stiff secant assumption in the EPSC formulation, is resolved with a second step in which CPFE is used to iteratively refine the EPSC-estimated parameters. Remarkably close agreement is obtained between the theoretically-predicted and experimentally derived flow curve for the QP980 material.

a b s t r a c tFinite element analysis was performed over a small particle field, edge constraint plane strain post-necking model. The aim is to understand the roles of particle shape, volume fraction and distribution over the post-necking deformation and fracture of AA5754-O sheet materials. For models containing one single particle, the post-necking deformation decreases when the particle varies from circular to elliptical. The inter-particle spacing, the major parameter of distribution to determine whether a pair of particles belongs to a stringer or not, was varied for models with two particles of circular or elliptical shape. The general trend is that the post-necking deformation and fracture strains decrease with decreasing spacing between particles. There is considerable difference in terms of both fracture topographies and strains for models containing 16 particles when distributions varied from random/uniform to stringer distributions. The post-necking deformation and fracture strains monotonically decrease with particle volume fractions for models with 4-64 particles of random or stringer distribution. This indicates that the post-necking behavior for AA5754-O alloys where the matrix material is rather ductile is not solely controlled by a single or pair of particles although they may become initiation places of damage. Multiple damaging sources such as stringers or large particles can act cooperatively and speed up the damaging propagation of the material, and therefore produce small post-necking deformation and early fracture. The center clustering of particles can be beneficial for post-necking behavior and bendability of sheet materials.