Combined Langmuir-Blodgett vertical withdrawing and Langmuir-Schaefer horizontal touch (LB-LS) methods were employed to transfer DMPC bilayers onto a Au(111) electrode surface. Charge density measurements and photon polarization modulation infrared reflection absorption spectroscopy were employed to investigate electric field induced changes in the structure of the bilayer. The results show that the physical state and the molecular arrangement found in the monolayer at the air-water interface is to a large extent preserved in the bilayer formed by the LB-LS method. This approach provides an opportunity to produce supported bilayers with a well-designed architecture. The properties of the bilayer formed by the LB-LS method were compared to the properties of the bilayer produced by spontaneous fusion of unilamellar vesicles investigated in an earlier study (Bin, X.; Zawisza, I.; Lipkowski, J. Langmuir 2005, 21, 330-347). The tilt angles of the acyl chains are much smaller in the bilayer formed by the LB-LS method and are closer to the angles observed for vesicles and stacked hydrated bilayers. The tilt angles of the phosphate and choline groups are also smaller and are characteristic of an orientation in which the area per DMPC molecule is small. The electric field induced changes of these angles are also less pronounced in the bilayer formed by the LB-LS method. We have shown that these differences are a result of the higher packing density of the phospholipid molecules in the bilayer formed by the LB-LS method.

Differential capacity, charge density measurements, and polarization modulation infrared reflection absorption spectroscopy (PM-IRRAS) were employed to study the fusion of small unilamellar vesicles of 1,2-dimyristoyl-sn-glycero-3-phosphocholine (DMPC) on a Au(111) electrode surface. The differential capacity and charge density data showed that the vesicles fuse onto the gold surface at charge densities between -10 microC/cm(2) < sigma(M) < 10 microC/cm(2) to form a bilayer. When sigma(M) < -10 microC/cm(2), the film is detached from the surface but it remains in close proximity to the surface. PM-IRRAS experiments provided IR spectra for the bilayer in the adsorbed and the desorbed state. Ab initio normal coordinate calculations were performed to assist interpretation of the IR spectra. The IR bands were analyzed quantitatively, and this analysis provided information concerning the conformation and orientation of the acyl chains and the polar head region of the DMPC molecule. The orientation of the chains, hydration, and conformation of the headgroup of the DMPC molecule strongly depend on the electrode potential.

Detection of biomolecules at low abundances is crucial to the rapid diagnosis of disease. Impressive sensitivities, typically measured with small model analytes, have been obtained with a variety of nano- and microscale sensors. A remaining challenge, however, is the rapid detection of large native biomolecules in real biological samples. Here we develop and investigate a sensor system that directly addresses the source of this challenge: the slow diffusion of large biomolecules traveling through solution to fixed sensors, and inefficient complexation of target molecules with immobilized probes. We engineer arrayed sensors on two distinct length scales: a ∼100 μm length scale commensurable with the distance bacterial mRNA can travel in the 30 min sample-to-answer duration urgently required in point-of-need diagnostic applications; and the nanometer length scale we prove necessary for efficient target capture. We challenge the specificity of our hierarchical nanotextured microsensors using crude bacterial lysates and document the first electronic chip to sense trace levels of bacteria in under 30 min.