Wave equation wave field numerical modeling technology is applied to the observation that deep layer imaging is difficult below a screening layer of high-velocity basalt. Three simple high-velocity basalt models are designed on the basis of basalt formation characteristics. The analysis of deep-layer reflection seismic signal energy shows that lowfrequency seismic signals are capable of both penetrating the thin high-velocity basalt layer and reducing the diffraction noise caused by the rough surfaces. The simulation experiment of a complete 2D basalt model confirms that the low-frequency signals can be used to boost the quality of deep-layer imaging under the high-velocity basalt layer and achieve good results in low-pass filter processing of actual data.

The effect of flow coefficients, working pressures, nozzle layout and aircraft angle on extinguishing aircraft cabin fire by water mist were studied by experiment. The results show that the fire suppression effectiveness is increased with the increase of flow coefficient and working pressure; the diamond-shaped layout in sprinkler is better than square layout,and the aircraft angle of 30° is better than of 10°or 20°.

The objective of this work is to investigate the diesel analog pool fire with water mist .For this purpose, a series of water mist fire suppression experiment are carried out by changing the nozzle operating pressure, the source of fire power, opening and closing the exhaust fan to analyze the inhibitory effect of water mist to oil pool fire in the enclosed compartment of 5.0m × 5.0m × 3.0m. The results shows that extinguishing efficiency first increases and then decreases when the nozzle operating pressure increases from 8MPa to 12MPa, reaching the highest efficiency at 10MPa; increasing the power of the source of fire, the burning speed increases and the water mist fire extinguishing efficiency decreases; fresh oxygen coming in when smoke exhaust fan is turned on and water mist fire suppression efficiency decreases. Using FDS to simulate the water mist extinguishing oil pool fire, the predict temperature field and extinguishing time are basically consistent with the experimental results. In the actual applications of water mist fire suppression systems engineering, we can use the FDS field simulation methods to predict the characteristic parameters variation of the fire fighting fire temperature and component concentration, which is significant to the fire extinguishing system optimized design.

This paper presents an experimental study of fire suppression effectiveness with water mist containing FeCl2 additives.The investigation focuses on suppression effectiveness under various FeCl2 additives concentrations,working pressures and nozzle different height above the fire source . The experimental results show that: there is a significant impact on fire suppression effectiveness when adding FeCl2 to water mist. There is an optimum additive concentration of extinguishing fire, corresponding to the shortest extinguishing time, the least amount of water, the highest efficiency of extinguishing fire. The nozzle working pressures and nozzle position have effect on the performance of the water mist extinguishing: the greater the pressure is, the shorter water mist fire extinguishing time is. Under the same experimental conditions, the closer the water mist nozzles are to the oil pan, the shorter extinguishing time is.