Rotating stall is a natural limit to the stable operating range of compressors due to the inverse pressure gradient of viscous gas. Effective prediction of compressor stall boundary is an important guarantee for the successful development of aeroengine. In this paper, a three-dimensional unsteady through-flow model based on body force theory is developed to reflect the dynamic stall process of multistage axial compressors with acceptable computational costs. The influence of blade geometric parameters is fully considered in blade force source terms. The source terms are related to the attack angle and Mach number of the blade inlet using the deviation angle and loss model in the through-flow theory. Meanwhile, the temporal lag response of the source terms to the upstream flow conditions is taken into account. Therefore, it can be utilized for predicting the off-design performance and rotating stall characteristics of multistage axial compressors. The developed model is validated on a two-stage low-speed axial compressor. The calculated performance line and stall cell speed are in agreement with the experimental results. The unsteady flow behavior of the compressor during stall is presented by the model. The results indicate that the developed model has the potential to be applied to the preliminary evaluation of compressor stability in design stage.

No abstract

In this paper, an experimental study was carried out on the rotating instability in an axial compressor subjected to inlet steady paired swirl distortion. In order to deepen the understanding of the rotating stall mechanism under inlet steady paired swirl distortion, the dynamic-wall static pressure near the rotor tip was monitored to characterize the flow in the rotor tip region at different circumferential stations. In the experiment, the dynamic characteristics of the rotor tip flow field at a stable operating point and during the process from the stable point to complete stall were measured. The results indicated that for the compressor with a 2 mm rotor tip clearance, the inlet paired swirl distortion induced rotating instability (RI) near the stall point, causing the compressor to enter stall in advance. Compared with the RI intensity of the clean inlet, the distortion with a swirling blade stagger angle (αst) of ±20° increased the RI intensity up to 69.8%, while for αst equal to ±40°, the RI intensity increased at most by 135.8%. As the rotor tip clearance increased to 3 mm, the co-rotating swirl in the paired swirl distortion inhibited the appearance of RI, while the counter-rotating part aggravated the development of RI. At the beginning, the process of the compressor rotating stall involved the alternation of short-scale disturbance and long-scale disturbance. The co-rotating swirl weakened the perturbation propagated from the counter-rotating swirl sector. Once the inhibition was no longer present, the short-scale disturbance rapidly developed into a long-scale disturbance and then entered the rotating stall.

The aim of this article mainly lies in two aspects. The first is to investigate the effect of inlet swirl distortion on the performance and stability of a low-speed compressor experimentally. The second is to quantify swirl pattern revolution through the compressor and find out background causes of the change in compressor performance. Swirl distortion makes the leading-edge incidence opposite between tip and hub regions, compared to that of clean flow. And the compressor performance change is ultimately determined by these two aspects. Results indicate that negative bulk swirl improves pressure rise, and the effect is on the contrary to the positive bulk swirl. Under the condition of paired swirl, pressure rise also presents a reduction. All these three types of swirl have little effect on the stall boundary. Although swirl distortion shows clear recovery at rotor exit, downstream components still work at off-design conditions due to the induced nonuniformity in axial velocity and total pressure.

No abstract