Direct chemical sensing in liquid environments using polymer-guided shear horizontal surface acoustic wave sensor platforms on 36° rotated Y-cut LiTaO3 is investigated. Design considerations for optimizing these devices for liquid-phase detection are systematically explored. Two different sensor geometries are experimentally and theoretically analyzed. Dual delay line devices are used with a reference line coated with poly (methyl methacrylate) (PMMA) and a sensing line coated with a chemically sensitive polymer, which acts as both a guiding layer and a sensing layer or with a PMMA waveguide and a chemically sensitive polymer. Results show the three-layer model provides higher sensitivity than the four-layer model. Contributions from mass loading and coating viscoelasticity changes to the sensor response are evaluated, taking into account the added mass, swelling, and plasticization. Chemically sensitive polymers are investigated in the detection of low concentrations (1−60 ppm) of toluene, ethylbenzene, and xylenes in water. A low-ppb level detection limit is estimated from the present experimental measurements. Sensor properties are investigated by varying the sensor geometries, coating thickness combinations, coating properties, and curing temperature for operation in liquid environments. Partition coefficients for polymer−aqueous analyte pairs are used to explain the observed trend in sensitivity for the polymers PMMA, poly(isobutylene), poly(epichlorohydrin), and poly(ethyl acrylate) used in this work.

Attenuated total internal reflectance Fourier transform infrared (ATR-FTIR) spectroscopy was used for the investigation of sorption of aqueous solutions of analytes into polymer coatings. A series of simple model polymers: poly(dimethylsiloxane) (PDMS), poly(epichlorhydrin) (PECH), and poly(isobutylene) (PIB) films and analytes: aqueous solutions of ethylbenzene, xylenes, toluene, and nitrobenzene were used to evaluate the use of ATR-FTIR spectroscopy as a screening tool for sensor development. The ratios of integrated infrared absorption bands provided a simple and efficient method for predicting trends in partition coefficients. Responses of polymer-coated guided shear horizontal surface acoustic wave (SH-SAW) sensor platforms to the series of analytes, using polymer coatings with similar viscoelastic properties, were consistent with ATR-FTIR predictions. Guided SH-SAW sensor responses were linear in all cases with respect to analyte concentration in the tested range. Comparison of ATR-FTIR data with guided SH-SAW sensor data identifies cases where mass loading is not the dominant contribution to the response of the acoustic wave sensor. ATR-FTIR spectra of nitrobenzene, coupled with computational chemistry, provided additional insight into analyte/polymer interactions.

For several decades, cancer has been one of the most life-threatening diseases. For enhancing anticancer efficiency with minimum side effects, combination therapy is envisioned. The current manuscript reports for the first time the development of a methylene blue (MB) bound nanoplatform, which is capable of delivering targeted diagnostic and combined synergistic photothermal and photodynamic treatment of cancer. Experimental data found that, once the nanoparticle binds with the target cell surface, it can detect LNCaP human prostate cancer cell selectively using fluorescence imaging. Our result shows that the therapeutic actions can be controlled with external NIR light. No cytotoxicity was observed in the absence of NIR light. Targeted photodynamic and photothermal treatment using 785 nm NIR light indicates that the multimodal treatment enhances the possibility of destroying LNCaP prostate cancer cells in vitro dramatically. We discuss the operating principle for the targeted imaging and possible mechanisms for combined therapeutic actions. Our experimental data show that NIR light activated combined therapy for cancer may become a highly effective treatment procedure in clinical settings.