Bdelloid rotifers are microinvertebrates with unique characteristics: they have survived tens of millions of years without sexual reproduction; they withstand extreme desiccation by undergoing anhydrobiosis; and they tolerate very high levels of ionizing radiation. Recent evidence suggests that subtelomeric regions of the bdelloid genome contain sequences originating from other organisms by horizontal gene transfer (HGT), of which some are known to be transcribed. However, the extent to which foreign gene expression plays a role in bdelloid physiology is unknown. We address this in the first large scale analysis of the transcriptome of the bdelloid Adineta ricciae: cDNA libraries from hydrated and desiccated bdelloids were subjected to massively parallel sequencing and assembled transcripts compared against the UniProtKB database by blastx to identify their putative products. Of ∼29,000 matched transcripts, ∼10% were inferred from blastx matches to be horizontally acquired, mainly from eubacteria but also from fungi, protists, and algae. After allowing for possible sources of error, the rate of HGT is at least 8%–9%, a level significantly higher than other invertebrates. We verified their foreign nature by phylogenetic analysis and by demonstrating linkage of foreign genes with metazoan genes in the bdelloid genome. Approximately 80% of horizontally acquired genes expressed in bdelloids code for enzymes, and these represent 39% of enzymes in identified pathways. Many enzymes encoded by foreign genes enhance biochemistry in bdelloids compared to other metazoans, for example, by potentiating toxin degradation or generation of antioxidants and key metabolites. They also supplement, and occasionally potentially replace, existing metazoan functions. Bdelloid rotifers therefore express horizontally acquired genes on a scale unprecedented in animals, and foreign genes make a profound contribution to their metabolism. This represents a potential mechanism for ancient asexuals to adapt rapidly to changing environments and thereby persist over long evolutionary time periods in the absence of sex.

Nickel superalloys exhibit a remarkable characteristic. Their yield stress that required to cause the onset of plastic deformation increases with temperature. This typically occurs up to a temperature of around 800°C. This effect is thought to originate from the precipitates of the microstructure, which have an L12-ordered crystal structure. A number of other L12-based alloys exhibit similar yield properties. It is generally accepted that this is caused by the exhaustion of dislocations by cross-slip from {111} glide planes to {010} planes on which they are sessile. However, the underlying mechanisms that control this cross-slipping process are yet to be fully understood, with little consistency between empirical results and theory. A critical review of the various theories surrounding nickel superalloys is offered.

Perforation of a Meckel diverticulum in a preterm neonate is very rare. To our knowledge, only 7 cases of spontaneous Meckel perforation in a preterm neonate have previously been described in the literature. The etiology is uncertain. We present the case of a 30-week preterm female twin with a spontaneous Meckel diverticulum perforation discovered on day 3 of life and review the published cases. A possible etiological explanation for this rare entity at this age group is also suggested.

Single crystal Nickel-based superalloys exhibit an anomalous yield point, the yield stress increasing with temperature to a maximum at around 750 ºC. Here, we demonstrate in the alloy CMSX-4 at 750 ºC that, although there is virtually no effect of strain rate on the initial yield point, at slow strain rates a second mechanism can initiate leading to a considerable softening effect. By examining the microstructures of a series of interrupted tests, this is attributed to the initiation of stacking fault shear after the operation of a secondary slip system. Using high-resolution TEM, the dislocation structures are shown to be identical in both structure and in the segregation of Co, Cr, and W, to those observed during creep deformation of single crystal alloys, although the conformation of the dislocations and faults differs from that observed during creep. This drop in flow stress at low strain rates is not observed in the alloys TMS138A and SRR99, in the former case, the improved creep resistance of this fourth-generation alloy would require a much slower strain rate to match the creep rate achievable at this temperature.