Through the analysis of present research and application situation of binocular stereo vision system, the paper indicates an opinion that the structural parameters of system are crucial to the measurement accuracy of system. This paper focuses on several parameters to discuss the effect on the measurement accuracy, such as the distance of baseline, angles between optical axis and baseline, projection angles and so on. According to measuring principle and mathematical model of binocular stereo vision system, through deriving formulas and drawing curves by means of MATLAB, the impact that different structural parameter has on measurement accuracy is analyzed. Finally, the correctness of theoretical analysis is proved by experiment and the research result is summarized.

The porcine infrapatellar fat pad is a structure composed of adipocytes and adipose connective tissues. Limited information is available concerning its chemical composition. Samples of the fat pad collected from young hogs were dissected into two portions: a relatively hard core of the pad with cushioning properties (inner tissue), and a soft adipose tissue surrounding the core (outer tissue). The inner tissue contained less moisture and nitrogen than did the outer tissue. The yield of dry-delipidated tissue was also lower in the inner tissue, indicating a higher content of lipid in this tissue. Fatty acid analysis showed that the proportions of C18: 1, C16: 1 and C18: 2n-6 are higher, and the proportion of C16: 0 is lower in the inner than in the outer tissue. Collagen is the major protein, with relatively small amounts of glycosaminoglycans in both tissues. The content of hyaluronic acid relative to sulphated galactosaminoglycan was lower in the inner than in the outer tissue. The electrophoresis pattern of sulphated galactosaminoglycan was also different between the two tissues. These results suggest that chemical composition varies between adipose tissues with different biomechanical function.

Current limiting reactor can increase systems short circuit impedance so as to limit short circuit current. Current limiting reactor is directly involved in whole short circuit process when a short circuit fault occurs in a power system, which makes short-circuit current change more complex. Short circuit current level is affected by current limiting reactors parameters; a current limiting reactor with proper impedance value can maintain short-circuit current at an acceptable range. A short circuit transient process of a distributing network with current limiting reactor was analyzed, and the formula of current changing in short circuit transient process was deduced; according to the current changing formula, an engineering calculation formula of current limiting reactors impedance was derived. The case calculation shows that current limiting reactor meeting the need of the engineering calculation formula can reach the system current limiting requirement.

In this paper, the impact on carrier capture of high dynamic and low SNR signal in satellite communication caused by the rate of change of the carrier frequency offset is analyzed. Firstly, the existing large carrier frequency offset estimate technology is described. Secondly, the rate of change of the carrier frequency offset impact on the carrier frequency offset is analyzed. Finally, the Doppler shift characteristics of Low SNR high dynamic signal and performance impact on the capture carrier are simulated by MATLAB. The results showed that the rate of change of Doppler shift will seriously affect the number of non-coherent accumulation times of the carrier frequency offset estimate.

Active service is a kind of Web service which can be customized by customer’s requirement. The development of component technology provides foundation for the implementation of active services. Based on UCDL, the key technology of Local Component Resource Warehouse (LCRW) is expounded, the model of component library based on active service is constructed, the organization method by facet classification combined with ontology information classification is proposed, and the component retrieval based on Ontology Information is also proposed in view of facet retrieval.