Steel-reinforced concrete-filled steel tubular (SRCFST) columns have a great development prospect in engineering practice due to their high load-bearing capacity, good ductility, and energy consumption capacity. This paper established the post-fire seismic analysis model of SRCFST with a circular-cased H section using the sequential coupled thermal-stress method by ABAQUS. The P-Δ curve, stiffness, ductility, and energy dissipation were calculated. Then, the post-fire seismic performance of CFST members was compared while keeping the total steel ratio constant, and it revealed that the SRCFST had superior ductility to CFST. Finally, the ductility coefficient and skeleton curve were parametrically evaluated. The results of the study showed that the effects of heating time (th), axial compression ratio (n), slenderness ratio (λ), and steel tube ratio (αt) on the skeleton line of SRCFST columns are more significant; the axial compression ratio (n), slenderness ratio (λ), and steel tube ratio (αt) have a negative influence on the ductility subjected to post-fire.

No abstract

To reveal the temperature characteristics and mechanical properties of frame structures with concrete filled steel tube reinforced concrete (CFSTRC) columns under fire, the fire resistance of four planar frames consisting of CFSTRC columns and reinforced concrete (RC) beams subjected to ISO-834 standard fire was tested in this study. The test parameters included the column fire load ratio, beam fire load ratio, and beam-to-column linear stiffness ratio. In the test, the temperatures of the column, beam, and slab cross-sections in the joint and nonjoint zones were measured, and the fire resistance, beam and column deformation curves, and failure modes of the frame were investigated. The experimental results showed that the concrete volume was the main factor affecting the temperature distribution on each typical cross-section of the frame: the temperatures at the measuring points of the beam and column in the joint zone were significantly lower than the temperatures at the corresponding points in the nonjoint zone, and the concrete outside the steel tube significantly slowed the propagation of temperature to the steel tube and its concrete core. Hence, there was only a small loss of the bearing capacity of steel tube and the core concrete inside the steel tube. The column fire load ratio, beam fire load ratio, and beam-to-column linear stiffness ratio have obvious influences on the fire resistance: the larger the column fire load ratio or beam fire load ratio, the smaller the fire resistance; and the larger the beam-to-column linear stiffness ratio, the larger the fire resistance.

Based on the finite element (FE) analysis software Abaqus, an FE model of square-cased square steel tube reinforced concrete (ST-RC) columns under the hybridized action of high-temperature and load is established. The accuracy of the FE model is verified using experimental data from existing studies. This model is used to analyze the temperature change, internal force distribution, and failure characteristics of the square-cased square ST-RC columns under the action of fire, as well as the factors affecting the fire resistance limit of the column. The results of FE analysis show that under the action of fire, the maximum internal temperature of the square-cased square ST-RC columns occurs in the corner of the section. Moreover, the stress and strain reach their maximum values at the concrete corner outside the tube. During the heating process, an internal force redistribution occurs in the square-cased square ST-RC column. At the same time, the proportion of the axial force and the bending moment of the reinforced concrete outside the pipe decreases gradually, while the proportion of the internal force of the core concrete-filled steel tube (CFST) increases gradually. In essence, it is a process of load transfer from the high-temperature to the low-temperature zone. In addition, the section size, load ratio, slenderness ratio, cross-sectional core area ratio, steel content, and external concrete strength are the main parameters affecting the fire resistance limit of the square-cased square ST-RC columns. Among them, the cross-sectional core area ratio, section size, steel ratio, and external concrete strength are positively correlated with the fire resistance limit of the composite column. On the contrary, with the increase in the load ratio and the slenderness ratio, the fire resistance limit of the square-cased square ST-RC columns decreases. On this basis, a simplified formula to calculate the fire resistance limit of square-cased square ST-RC columns is proposed. The research results can be used as a theoretical reference for the fire protection design of this kind of structure in practical engineering.

The traditional wave impeding block (WIB) is designed as composite multilayer WIB with the same thickness to improve its vibration isolation effect. Based on the wave theory in unsaturated porous medium and elastic medium, the isolation effect of composite multilayer WIB on P-wave in unsaturated soil is investigated, and the solution of the vertical displacement at surface after setting composite multilayer WIB (as an example for triple-layer) in unsaturated foundation is obtained. The key factors such as incidence angle, frequency, saturation, thickness, and burial depth of the composite multilayer WIB are evaluated on its vibration isolation properties. The results show that the optimum vibration isolation effect can be achieved by controlling the wave impedance ratio among layers of materials. The isolation efficiency of composite multilayer WIB is 33.9% higher than homogeneous WIB with same thickness at l east, and has good vibration isolation effect for low, medium, and high frequency.