The interaction of 91.6eV EUV photons with photoresist is very different to that of optical lithography at DUV wavelength. The latter is understood quite well and it is known that photons interact with the resist in a molecular way through the photoacid generator (PAG) of the chemically amplified resist (CAR). In EUV however, the high energy photons interact with the matter on atomic scale, resulting in the generation of secondary electrons. It is believed that these secondary electrons in their turn are responsible in chemical modification and lead to switching reactions that enable resist local dissolution. However, details of the interaction are still unclear, e.g. which reaction an electron with a given energy can initiate.In this work we have introduced a method to measure the chemical interaction of the secondary electrons with the EUV resist. The method is based on electron gun exposures of low energy electrons (range ~1eV to ~80eV) in the photoresist. The chemical interaction is then measured by Residual Gas Analysis (RGA), which can analyze out of the outgassing which and how much reaction products are generated. In this way a 'chemical yield' can be quantified as function of electron energy. This method has been successfully applied to understand the interaction of secondary electrons on the traditional CAR materials. The understanding was facilitated by testing different compositions of an advanced EUV CAR, where resp. polymer only, polymer+PAG, and polymer+PAG+quencher are tested with the electron gun. It was found that lowenergy electrons down to ~3-4eV can activate PAG dissociation, which can lead to polymer deprotection. However it was observed too that energy electrons of ~12eV and higher can do direct deprotection even in absence of the PAG. In addition, testing suggests that electrons can generate also other chemical changes on the polymer chain that could lead to cross-linking.

Extreme ultraviolet lithography (EUVL) is a leading-edge technology for pattern miniaturization and the production of advanced electronic devices. One of the current critical challenges for further scaling down the technology is reducing the line-edge roughness (LER) of the final patterns while simultaneously maintaining high resolution and sensitivity. As the target sizes of features and LER become closer to the polymer size, polymer chain conformations and their distribution should be considered to understand the primary sources of LER. Here, we proposed a new approach of EUV photoresist modeling with an explicit description of polymer chains using a coarse-grained model. Our new simulation model demonstrated that interface variation represented by width and fluctuation at the edge of the pattern could be caused by characteristic changes of the resist material during the lithography processes. We determined the effect of polymer chain conformation on LER formation and how it finally contributed to LER formation with various resist material parameters (e.g., Flory–Huggins parameter, molecular weight, protected site ratio, and Tg).

The evolutionary advances in photosensitive material technology, together with the shortening of the exposure wavelength in the photolithography process, have enabled and driven the transistor scaling dictated by Moore’s law for the last 50 years. Today, the shortening wavelength trend continues to improve the chips’ performance over time by feature size miniaturization. The next-generation lithography technology for high-volume manufacturing (HVM) is extreme ultraviolet lithography (EUVL), using a light source with a wavelength of 13.5 nm. Here, we provide a brief introduction to EUVL and patterning requirements for sub-0-nm feature sizes from a photomaterial standpoint, discussing traditional and novel photoresists. Emphasis will be put on the novel class of metal-containing resists (MCRs) as well as their challenges from a manufacturing prospective.