Simultaneously enhancing multiple antenna performance parameters is a demanding task, especially with a challenging set of design goals. In this paper, by carefully deriving a compatible set of enhancement techniques, we propose a compact/lightweight/low-cost high-performance L-band octagonal cavity-backed hybrid antenna with multiple attractive features: dual-polarization, wide impedance bandwidth, low cross-polarization, high gain, and high aperture efficiency. The ground cavity is octagonal, which allows the antenna to have a small footprint, and, more importantly, low cross-polarization and high aperture efficiencies when compared to a commonly-used square design. The hybrid design relies on the resonance merging of two radiating elements, i.e., radiating feedlines and a conductive open prism, to form a wide impedance bandwidth. To permit polarization diversity and low cross-polarization, it is differentially and orthogonally fed. Herein, a series of parametric simulation studies on antenna configurations provide information on how to improve the impedance bandwidth and cross-polarization performance. To verify the simulation studies, an antenna prototype was fabricated and tested. Excellent agreement between the simulated and measured results was reached.

Herein, we present new design principles for gain enhancement and cross-polarization suppression in dual-polarized cavity-backed antennas and demonstrate the capability in an octagonal cavity-backed open prism antenna (OCROP). In our approach, the gain is enhanced through an optimal flaring procedure and a novel metallic iris is used to control the electromagnetic fields and thereby reduce the cross-polarization. Previously, we investigated a dual-polarized OCROP antenna configuration and were able to simultaneously achieve 50% impedance bandwidth, 40% cross-polarization bandwidth (≤25 dB), and 10.2 dBi peak gain. In this study, we investigated gain enhancement by flaring an upper section of the ground cavity sidewalls, while maintaining a constant cavity height. Two cases were investigated: (1) the flare angle was modified, while the ratio of the non-flared to flared sidewall heights was kept constant, and (2) the ratio of the non-flared to flared sidewall heights was varied. In case 1, we established that, while increasing the flare angle results in a gain increase, there is a limit, as cross-polarization at the upper operating frequencies increases. In case 2, we were able to reduce the aperture phase error and achieve a higher peak gain of 12.8 dBi. To address the increased cross-polarization at the high frequency end when a large flare was used, we added a metallic iris at the junction of non-flared and flared sidewalls. We showed that increasing the iris width generally decreases the cross-polarization at high frequencies, without compromising the gain and impedance bandwidth. At an optimal width, it provides a nearly constant, low cross-polarization (below −25.8 dB) and a peak gain of 13.3 dBi, across the entire 50.7% impedance bandwidth of the antenna. We fabricated and successfully tested a prototype to verify the design and simulation approach. These results prove that incorporating an aperture flare with a metallic iris can significantly improve the gain and cross-polarization performance of cavity-backed antennas.

This paper investigates the miniaturization capability of split ring array antennas embedded in a low-permittivity dielectric substrate, in comparison with the same-sized high-permittivity dielectric resonator antennas (DRAs). In order to understand the miniaturization performance, a size-fixed dielectric substrate with different split ring arrays is studied. The simulation results show that the miniaturization capability increases with decreased unit cell resonant frequency and/or increased unit cell induced permeability. Miniaturizations as high as 25.54 times that of a high-permittivity DRA are obtained with split rings, etched on a dielectric substrate having a low permittivity of 2.2. Furthermore, this excessive miniaturization does not come at the expense of excessive deterioration of the antenna impedance bandwidth, gain, and radiation efficiency. Consequently, the miniaturized split ring arrays still provide high gains over wider bandwidths. This inference is further verified by comparing the miniaturization and other antenna performance parameters with three other modified split ring configurations. To experimentally verify this work, a split ring antenna was fabricated and tested, and good agreement between the simulated and measured results was observed. The results of this study indicate that adding resonant metallic inclusions into low- permittivity DRAs significantly increases their miniaturization capability, without overly deteriorating the performance.