Dual-motor electric drive tracked vehicles (DDTVs) have drawn much attention in the trends of hybridization and electrification for tracked vehicles. Their transmission chains differ significantly from the traditional ones. Due to the complication and slug of a traditional tracked vehicle braking system, as well as the difference of track-ground with tire-road, research of antilock braking control of tracked vehicles is rather lacking. With the application of permanent magnet synchronous motors (PMSMs), applying an advanced braking control strategy becomes practical. This paper develops a novel emergency braking control strategy using a sliding mode slip ratio controller and a rule-based braking torque allocating method. Simulations are conducted under various track-ground conditions for comparing the control performance of the proposed strategy with three other strategies including the full braking strategy, traditional antilock braking strategy, as well as sliding mode slip ratio strategy without the use of motors. For an initial speed of 80 km/h, simulation results show that the proposed control strategy performs the best among all strategies mentioned above. Several hardware-in-the-loop (HIL) experiments are conducted under the same track-ground conditions as the ones in the simulations. The experiment results verified the validity of the proposed emergency braking control strategy.

For electrified transportation (eTransportation) systems, multi-phase motors can provide higher performance and reliability than three-phase ones, but also bring more challenges in their optimal design and control. In this article, a set of high reliable electric drive system based on dual three-phase permanent magnet synchronous motor (DTP PMSM) is developed for auxiliary systems in eTransportation field. A digital collaborative develop process is proposed with the support of multiple software tools. Design, manufacture, and bench testing stages of the DTP PMSM, the two-level six-phase inverter, and the control algorithm are efficiently incorporated. A prototype of the multi-phase electric drive system is fabricated and tested. Comparison of the simulation analysis and experimental results confirms the effectiveness of the collaborative develop progress. Control algorithms based on dual d-q model and vector space decomposition model are both verified and compared via the bench test. Operation mode switching from six-phase mode to three-phase mode is also realized with the prototype system, verifying its capability in fault-tolerant and potential in efficiency optimizing. INDEX TERMS Dual three-phase motor, auxiliary electric drive system, transportation electrification, digital collaborative development, motor design and control.

With the increasing importance of energy conservation emission reduction, the research about how to improve the operating efficiency of asynchronous motor has become a hot topic in the field of high-performance transmission. Among many efficiency optimization algorithms, the control method based on loss model (LMC) is widely concerned because of its clear physical meaning and fast optimization speed. The core of LMC is to ensure that the instruction of optimized flux can be accurately controlled which can realize the complete decoupling of the torque and flux in the FOC. Based on the model of asynchronous motor considering iron loss, the paper deduces the flux expression of asynchronous motor and proposes an improved flux observer. Finally, the feasibility and effectiveness of the proposed control strategy are verified by simulation and experiment.

No abstract

No abstract