In this work, we study the detection of acetylene (C2H2), carbon dioxide (CO2) and water vapor (H2O) gases in the near-infrared (NIR) range using an on-chip silicon micro-electro-mechanical system (MEMS) Fourier transform infrared (FT-IR) spectrometer in the wavelength range 1300-2500 nm (4000-7692 cm(-1)). The spectrometer core engine is a scanning Michelson interferometer micro-fabricated using a deep-etching technology producing self-aligned components. The light is free-space propagating in-plane with respect to the silicon chip substrate. The moving mirror of the interferometer is driven by a relatively large stroke electrostatic comb-drive actuator corresponding to about 30 cm(-1) resolution. Multi-mode optical fibers are used to connect light between the wideband light source, the interferometer, the 10 cm gas cell, and the optical detector. A wide dynamic range of gas concentration down to 2000 parts per million (ppm) in only 10 cm length gas cell is demonstrated. Extending the wavelength range to the mid-infrared (MIR) range up to 4200 nm (2380 cm(-1)) is also experimentally demonstrated, for the first time, using a bulk micro-machined on-chip MEMS FT-IR spectrometer. The obtained results open the door for an on-chip optical gas sensor for many applications including environmental sensing and industrial process control in the NIR/MIR spectral ranges.

The integration of microactuators within a silicon photonic chip gave rise to the field of optical micro‐electro‐mechanical systems (MEMS) that was originally driven by the telecommunication market. Following the latter's bubble collapse in the beginning of the third millennium, new directions of research with considerable momentum appeared focusing on the realization and applications of miniaturized instrumentation in biology, chemistry, physics and materials science. At the heart of these applications light interferometry is a key optical phenomenon, in which miniaturized scanning interferometers are the manipulating optical devices. Monolithic free‐space optical interferometers realized on a silicon chip take advantage of the recent progress in the microfabrication technology that is enabling accurate control of the etching depth, the aspect ratio, the verticality and the curvature of the etched surfaces. The fabrication technology, the library of micro‐optical and mechanical components, the realized architectures and their characterization are described in detail in this review, followed by a discussion of the foreseen challenges.

Miniaturized optical benches process free-space light propagating in-plane with respect to the substrate and have a large variety of applications, including the coupling of light through an optical fiber. High coupling efficiency is usually obtained using assembled micro-optical parts, which considerably increase the system cost and integration effort. In this work, we report a high coupling efficiency, monolithically integrated silicon micromirror with controlled three-dimensional (3D) curvature that is capable of manipulating optical beams propagating in the plane of the silicon substrate. Based on our theoretical modeling, a spherical micromirror with a microscale radius of curvature as small as twice the Gaussian beam Rayleigh range provides a 100% coupling efficiency over a relatively long optical path range. Introducing dimensionless parameters facilitates the elucidation of the role of key design parameters, including the mirror's radii of curvature, independent of the wavelength. A micromachining method is presented for fabricating the 3D micromirror using fluorinated gas plasmas. The measured coupling efficiency was greater than 50% over a 200-mm optical path, compared to less than 10% afforded by a conventional flat micromirror, which was in good agreement with the model. Using the 3D micromirror, an optical cavity was formed with a round-trip diffraction loss of less than 0.4%, resulting in one order of magnitude enhancement in the measured quality factor. A nearly 100% coupling was also estimated when matching the sagittal and tangential radii of curvature of the presented micromirror's surface. The reported class of 3D micromirrors may be an advantageous replacement for the optical lenses usually assembled in silicon photonics and optical benches by transforming them into real 3D monolithic systems while achieving wideband high coupling efficiency over submillimeter distances.