Introducing a charge into a solid such as a metal oxide through chemical, electrical, or optical means can dramatically change its chemical or physical properties. To minimize its free energy, a lattice will distort in a material specific way to accommodate (screen) the Coulomb and exchange interactions presented by the excess charge. The carrier-lattice correlation in response to these interactions defines the spatial extent of the perturbing charge and can impart extraordinary physical and chemical properties such as superconductivity and catalytic activity. Here we investigate by experiment and theory the atomically resolved distribution of the excess charge created by a single oxygen atom vacancy and a hydroxyl (OH) impurity defects on rutile TiO(2)(110) surface. Contrary to the conventional model where the charge remains localized at the defect, scanning tunneling microscopy and density functional theory show it to be delocalized over multiple surrounding titanium atoms. The characteristic charge distribution controls the chemical, photocatalytic, and electronic properties of TiO(2) surfaces.

We have investigated the mechanism of the chemical reaction of the benzene molecule adsorbed on Cu(110) surface induced by the injection of tunneling electrons using scanning tunneling microscopy (STM). With the dosing of tunneling electrons of the energy 2-5 eV from the STM tip to the molecule, we have detected the increase of the height of the benzene molecule by 40% in the STM image and the appearance of the vibration feature of the nu(C-H) mode in the inelastic tunneling spectroscopy (IETS) spectrum. It can be understood with a model in which the dissociation of C-H bonds occurs in a benzene molecule that induces a bonding geometry change from flat-lying to up-right configuration, which follows the story of the report of Lauhon and Ho on the STM-induced change of benzene on the Cu(100) surface. [L. J. Lauhon and W. Ho, J. Phys. Chem. A 104, 2463 (2000)]. The reaction probability shows a sharp rise at the sample bias voltage at 2.4 V, which saturates at 3.0 V, which is followed by another sharp rise at the voltage of 4.3 V. No increase of the reaction yield is observed for the negative sample voltage up to 5 eV. In the case of a fully deuterated benzene molecule, it shows the onset at the same energy of 2.4 eV, but the reaction probability is 10(3) smaller than the case of the normal benzene molecule. We propose a model in which the dehydrogenation of the benzene molecule is induced by the formation of the temporal negative ion due to the trapping of the electrons at the unoccupied resonant states formed by the pi orbitals. The existence of the resonant level close to the Fermi level ( approximately 2.4 eV) and multiple levels in less than approximately 5 eV from the Fermi level, indicates a fairly strong interaction of the Cu-pi(*) state of the benzene molecule. We estimated that the large isotope effect of approximately 10(3) can be accounted for with the Menzel-Gomer-Redhead (MGR) model with an assumption of a shallow potential curve for the excited state.

Inelastically tunneled electrons from a scanning tunneling microscope (STM) were used to induce vibrationally mediated motion of a single cis-2-butene molecule among four equivalent orientations on Pd(110) at 4.8 K. The action spectrum obtained from the motion clearly detects more vibrational modes than inelastic electron tunneling spectroscopy with a STM. We demonstrate the usefulness of the action spectroscopy as a novel single molecule vibrational spectroscopic method. We also discuss its selection rules in terms of resonance tunneling.