Clinical and radiographic outcomes between the 2 PCL reconstruction techniques were comparable. Osteoarthritis was observed in patients, with a significant proportion presenting loss of joint space. Examined factors, excluding meniscectomy, were not correlated with the development of osteoarthritis.

Backgrounds This study aimed to investigate the characteristic deformities of the hip in multiple hereditary exostoses patients (MHE) and its association with the hip impingement syndrome. Materials and methods Between 2001 and 2019, total 51 patients (102 hips) were evaluated in this study. Patients with MHE were classified to femoro-acetabular impingement (FAI) symptom group, ischio-femoral impingement (IFI) symptom group and non-impingement symptom group by comparing the symptoms, clinical signs and imaging studies. To assess the morphometry of the hip in patients with MHE, the femoral neck-shaft angle, Sharp’s acetabular angle and center-edge (CE) angle were evaluated. Alpha angle was further evaluated to investigate the FAI using radiographs, and the minimum ischio-femoral distance was further measured to investigate the IFI using computed-tomographic (CT) study. Results On hip impingement symptom analysis, FAI symptom and IFI symptom were confirmed in 14 hip joints and 18 hip joints, respectively. Unlike general population, the number of the hip with IFI-symptom was higher than those with FAI symptom in this study. In morphometric evaluation of MHE hips, coxa valga was most prominent deformity with occasional tendency of mild acetabular dysplasia. In a comparison of morphometric study between the impingement symptom group and non-symptom group, the FAI symptom showed significant differences of morphometric measure values than those of the non-symptom group (FAI symptom group vs. Non-FAI symptom group; Femoral neck-shaft angle (153.9 vs 142.6), Sharp’s angle (45.0 vs 41.5), CE angle (21.1 vs 28.8) and alpha angle (76.7 vs 57.9)). Similarly, the IFI symptom group also showed significant differences of morphometric measure values than those of the non-symptom group (IFI-symptom vs. Non-IFI symptom; Femoral neck-shaft angle (150.9 vs 142.7), Sharp’s angle (44.7 vs 41.4), CE angle (21.1 vs 29.3) and alpha angle (73.3 vs 56.8)). In addition, the minimum ischio-femoral distance measured using CT was significantly decreased in the IFI symptom group (IFI symptom group: 6.6, Non-IFI symptom group: 16.4). Conclusion The results suggest that the characteristic deformities represented by coxa valga in the MHE hip act as an offset for FAI symptoms, on the contrary, act as a trigger for IFI symptoms. Level of evidence Level III.

No abstract

No abstract

Background Anatomical total shoulder arthroplasty (aTSA) has been used to manage degenerative diseases such as primary osteoarthritis. An increase in the use of this procedure has led to several developments in humeral and glenoid components to improve patient outcomes. This study aimed to compare clinical and radiological outcomes of the newly-introduced convertible metal-backed glenoid components with cemented polyethylene glenoid components in aTSA, and to determine whether the new component would be comparable to a conventional one for reducing the burden of future revision or conversion surgeries. Methods Medical records of fifty patients who underwent aTSA with at least two years of follow-up were retrospectively reviewed. Eighteen patients received convertible metal-backed glenoid components with vitamin E1-coated liner (MB group), while thirty-two patients received conventional cemented polyethylene glenoid components (PE group). Pre- and postoperative clinical and radiological outcomes (acromion-greater tuberosity angle [AGA] and humeral lateral offset [LO]) at final follow-up were assessed. Radiolucent lines (RLLs) and loosening around the humeral and glenoid components were also evaluated. Results Clinical outcomes improved after surgery in both groups (all p < 0.001). The arc of rotation measured by AGA improved postoperatively in both groups (all p < 0.001), and AGA and LO were not different according to the type of glenoid components (all p > 0.05). Overall complication rates including RLLs of PE and MB groups were 43.8% (14/32) and 16.7% (3/18), respectively (p = 0.031). Although the PE group had more RLLs than did the MB group (p < 0.05), related symptoms and/or glenoid implant loosening were not observed in both groups. Subscapularis failure occurred in two patients in the PE group and in one in the MB group. Conclusion The convertible metal-backed glenoid implant with vitamin E1-coated liner may be a good alternative for considering the potential for an easier conversion to reverse total shoulder arthroplasty.