The need for renewable alternatives to traditional petroleum-derived plastics has driven recent interest in biobased composite materials that are sourced from carbon-neutral feedstocks. Lignin, an abundant plant-derived feedstock, has been a candidate for renewable materials; however, it is often difficult to blend with other biopolymers. In order to improve the miscibility of lignin with other bioplastics, we developed a catalytic and solvent free method for synthesis of a lignin–PLA copolymer. Graft polymerization of lactide onto lignin catalyzed by triazabicyclodecene (TBD) resulted in a lignin-g-poly(lactic acid) copolymer; chain length of the PLA is controlled by varying of the lignin/lactide ratio and preacetylation treatment. End-group analysis reveals high grafting efficiency and preferential grafting on lignin aliphatic hydroxyls over phenolic hydroxyls. The lignin-g-PLA copolymers display a glass transition temperature range from 45 to 85 °C and multiphase melting behavior. The lignin-g-PLA copolymers are used as dispersion modifiers in PLA-based materials to enhance UV absorption and reduce brittleness without a sacrifice in the modulus of elasticity.

Wood products are extensively used to make furniture items and construction materials; however, the majority contain formaldehyde-based adhesives that raise serious health concerns.

a b s t r a c tWell-dispersed starch-clay nanocomposites were prepared by adding a dilute clay dispersion to a solution of starch followed by coprecipitation in ethanol. The clay didn't significantly influence the type of crystalline structure of starch molecules although the amount of crystallinity appears to be somewhat lower in the nanocomposites. The nanocomposites show improved modulus and strength without a decrease in elongation at break. The increase in modulus and strength is 65% and 30%, respectively for the nanocomposite containing 5 wt.% clay compared to the unfilled starch materials. Further increases in clay result in deterioration in properties most likely due to poorer clay dispersion and lower polymer crystallinity. As the amount of water increases, the modulus of both pure starch and starch nanocomposites decreases, although the change is less pronounced in the nanocomposites suggesting that the addition of clay to form nanocomposites can improve the stability of starch-based products during transportation and storage.

Postgrowth thermal annealing of an InGaN/GaN quantum-well sample with a medium level of nominal indium content ͑19%͒ was conducted. From the analyses of high-resolution transmission electron microscopy and energy filter transmission electron microscopy, it was found that thermal annealing at 900 °C led to a quasiregular quantum-dot-like structure. However, such a structure was destroyed when the annealing temperature was raised to 950 °C. Temperature-dependent photoluminescence ͑PL͒ measurements showed quite consistent results. Blueshift of the PL peak position and narrowing of the PL spectral width after thermal annealing were observed.