No abstract

This article will describe the research status and the features of control system of the disc brakes of mine hoist. The disc brakes consist of body, outer cylinder, cylinder, piston, ring, disc springs, plunger, gate disk and other components. The disc brakes use the pre-load of disc springs to force the piston to move towards the brake disc, push the brake pads out, then the brake pads and drum brake disc contact and resulting in positive pressure, then the formation of friction produce a braking torque. When the brake system loose pads, the cylinder is filled with the pressure oil, which make the piston compresses the disc springs, and promote the brake pads to move back and then left brake disc, remove the braking force. The hydraulic circuit of the braking system chooses two-way parallel oil and four oil cylinder brake. A slip road set up a one-way throttle, making the slip road brake slightly delayed, which will achieve two stage braking and make work more stable. This disc brake is normally closed, which means when the hoist does not work, the brake is in the state of braking to prevent the occurrence of accidents. This brake is safe, reliable and sensitive in action. The materials of brake pads is rigid asbestos plastic, which have stable friction coefficient, good wear resistance, is not sensitive to the aqueous medium and salt spray,it has flexible installation location, and it is easy to use, adjust and maintain.

No abstract

Vibration characteristics of the thin-walled cylindrical pipe are affected by the liquid within the pipe. The natural frequencies and vibration modes of the pipe without liquid are analyzed by the theory of beam bending vibration and finite element model, which is based on the Timoshenko beam model. The first three natural frequencies and vibration modes of the pipe with or without liquid are acquired by experiments. As shown in the experiment results, the natural frequencies of the containing liquid pipe are lower than the natural frequencies of the pipe without liquid.

The ratcheting behavior of a steel pipe with assembly parts was examined under internal pressure and a cyclic bending load, which has not been seen in previous research. An experimentally validated and three dimensional (3D) elastic-plastic finite element model (FEM)-with a nonlinear isotropic/kinematic hardening model-was used for the pipe's ratcheting simulation and considered the assembly contact effects outlined in this paper. A comparison of the ratcheting response of pipes with and without assembly parts showed that assembly contact between the sleeve and pipe suppressed the ratcheting response by changing its trend. In this work, the assembly contact effect on the ratcheting response of the pipe with assembly parts is discussed. Both the assembly contact and bending moment were found to control the ratcheting response, and the valley and peak values of the hoop ratcheting strain were the transition points of the two control modes. Finally, while the clearance between the sleeve and the pipe had an effect on the ratcheting response when it was not large, it had no effect when it reached a certain value.