BackgroundThe periodontal ligament (PDL) plays a key role in alveolar bone remodeling and resorption during tooth movements. The prediction of tooth mobility under functional dental loads requires a deep understanding of the mechanical behavior of the PDL, which is a critical issue in dental biomechanics. This study was aimed to examine the mechanical behavior of the PDL of the maxillary central and lateral incisors from human. The experimental results can contribute to developing an accurate constitutive model of the human PDL in orthodontics.MethodsThe samples of human incisors were cut into three slices. Uniaxial tensile tests were conducted under different loading rates. The transverse sections (cervical, middle and apex) normal to the longitudinal axis of the root of the tooth were used in the uniaxial tensile tests. Based on a bilinear simplification of the stress–strain relations, the elastic modulus of the PDL was calculated. The values of the elastic modulus in different regions were compared to explore the factors that influence the mechanical behavior of the periodontal ligament.ResultsThe obtained stress–strain curves of the human PDL were characterized by a bilinear model with two moduli (E1 and E2) for quantifying the elastic behavior of the PDL from the central and lateral incisors. Statistically significant differences of the elastic modulus were observed in the cases of 1, 3, and 5 N loading levels for the different teeth (central and lateral incisors). The results showed that the mechanical property of the human incisors’ PDLs is dependent on the location of PDL (ANOVA, P = 0.022, P < 0.05). The elastic moduli at the middle planes were greater than at the cervical and apical planes. However, at the cervical, middle, and apical planes, the elastic moduli of the mesial and distal site were not significantly different (ANOVA, P = 0.804, P > 0.05).ConclusionsThe values of elastic modulus were determined in the range between 0.607 and 4.274 MPa under loads ranging from 1 to 5 N. The elastic behavior of the PDL is influenced by the loading rate, tooth type, root level, and individual variation.

This study selected the maxillary labial impacted canine as the research object to build the model of periodontal ligament (PDL) and simulate the process of orthodontic treatment. This paper obtained stress–strain curve by calculating and analyzing the data of nanoindentation experiments. The parameters were identified through curve fittings by ABAQUS. The fitting results show that the third-order Ogden model is in good agreement with the experimental data which demonstrate that the third-order Ogden model is able to reflect the material properties of the PDL. In this paper, orthodontic process of the maxillary labial impacted canine was simulated. The results show that inside and outside surfaces of PDL all have stress variation, the stress on the root apex and dental cervix of PDL is relatively large, the maximum appears at dental cervix and the minimum appears close to tooth impedance center.