No abstract

No abstract

No abstract

Heat transfer at the interfacial contact is a dominant factor in the thermal behavior of glass during nonisothermal glass molding process. Recent research is developing reliable numerical approaches to quantify contact heat transfer coefficients. In most previous studies, however, both theoretical and numerical models of thermal contact conductance in glass molding attempted to investigate this factor by either omitting surface topography or simplifying the nature of contact surfaces. In fact, the determination of the contact heat transfer coefficient demands a detailed characterization of the contact interface including the surface topography and the thermomechanical behavior of the contact pair. This paper introduces a numerical approach to quantify the contact heat transfer by means of a microscale simulation at the glass‐mold interface. The simulation successfully incorporates modeling of the thermomechanical behaviors and the three‐dimensional topographies from actual surface measurements of the contact pair. The presented numerical model enables the derivation of contact heat transfer coefficients from various contact pressures and surface finishes. Numerical predictions of these coefficients are validated by transient contact heat transfer experiments using infrared thermography to verify the model.

In metal cutting processes, the use of cutting fluids shows significant effects on workpiece surface quality by reducing thermomechanical loads on cutting tool and workpiece. Many efforts are made to model these thermomechanical processes, however without considering detailed heat transfer between cutting fluid, tool, and workpiece. To account for heat transfer effects, a coupling approach is developed, which combines computational fluid dynamics (CFD) and finite element method (FEM) chip formation simulation. Prior to the simulation, experimental investigations in orthogonal cutting in dry and wet cutting conditions with two different workpiece materials (AISI 1045 and DA 718) are conducted. To measure the tool temperature in dry as well as in wet cutting conditions, a two color pyrometer is placed inside an electrical discharge machining (EDM) drilled cutting tool hole. Besides tool temperature, the cutting force is recorded during the experiments and later used to calculate heat source terms for the CFD simulation. After the experiments, FEM chip formation simulations are performed and provide the chip forms for the CFD mesh generation. In general, CFD simulation and experiment are in reasonable agreement, as for each workpiece setup the measured temperature data are located between the simulation results from the two different tool geometries. Furthermore, numerical and experimental results both show a decrease of tool temperature in wet cutting conditions, however revealing a more significant cooling effect in a AISI 1045 workpiece setup. The results suggest that the placement of drilling holes has a major influence on the local tool temperature distribution, as the drilling hole equals a thermal resistance and hence leads to elevated temperatures at the tool front.