Vesicles made completely from diblock copolymers-polymersomes-can be stably prepared by a wide range of techniques common to liposomes. Processes such as film rehydration, sonication, and extrusion can generate many-micron giants as well as monodisperse, approximately 100 nm vesicles of PEO-PEE (polyethyleneoxide-polyethylethylene) or PEO-PBD (polyethyleneoxide-polybutadiene). These thick-walled vesicles of polymer can encapsulate macromolecules just as liposomes can but, unlike many pure liposome systems, these polymersomes exhibit no in-surface thermal transitions and a subpopulation even survive autoclaving. Suspension in blood plasma has no immediate ill-effect on vesicle stability, and neither adhesion nor stimulation of phagocytes are apparent when giant polymersomes are held in direct, protracted contact. Proliferating cells, in addition, are unaffected when cultured for an extended time with an excess of polymersomes. The effects are consistent with the steric stabilization that PEG-lipid can impart to liposomes, but the present single-component polymersomes are far more stable mechanically and are not limited by PEG-driven micellization. The results potentiate a broad new class of technologically useful, polymer-based vesicles.

No abstract

The direct preparation of amphiphilic graft copolymers from commercial poly(vinylidene fluoride) (PVDF) using atom transfer radical polymerization (ATRP) is demonstrated. Here, direct initiation of the secondary fluorinated site of PVDF facilitates grafting of the hydrophilic comonomer. Amphiphilic comb copolymer derivatives of PVDF having poly(methacrylic acid) side chains (PVDF-g-PMAA) and poly(oxyethylene methacrylate) side chains (PVDF-g-POEM) are prepared using this method. Surface segregation of PVDF-g-POEM additives in PVDF is examined as a route to wettable, foul-resistant surfaces on PVDF filtration membranes. Because of surface segregation during the standard immersion precipitation process for membrane fabrication, a PVDF/5 wt % PVDF-g-POEM membrane, having a bulk POEM concentration of 3.4 wt %, exhibits a near-surface POEM concentration of 42 wt % as measured by X-ray photoelectron spectroscopy (XPS). This membrane displays substantial resistance to BSA fouling compared with pure PVDF and wets spontaneously when placed in contact with water.

Poly­(lactic-co-glycolic acid) (PLGA) is the most prevalent polymer drug delivery vehicle in use today. There are about 20 commercialized drug products in which PLGA is used as an excipient. In more than half of these formulations, PLGA is used in the form of microparticles (with sizes in the range between 60 nm and 100 μm). The primary role of PLGA is to control the kinetics of drug release toward achieving sustained release of the drug. Unfortunately, most drug-loaded PLGA microparticles exhibit a common drawback: an initial uncontrolled burst of the drug. After 30 years of utilization of PLGA in controlled drug delivery systems, this initial burst drug release still remains an unresolved challenge. In this Review, we present a summary of the proposed mechanisms responsible for this phenomenon and the known factors affecting the burst release process. Also, we discuss examples of recent efforts made to reduce the initial burst release of the drug from PLGA particles.